
UNSOLVED
Responses (5)
Solutions (0)
The system is too old to support SDXC -- controllers for SDXC didn't exist when it was designed. This isn't a case of a system that's been abandoned -- the design is just too old to support the high density memory cards, and the hardware is part of the mainboard, so it cannot be upgraded.
LouisCyphre
4 Posts
377
0
Posted June 26th, 2015 15:00
Are you sure it's not something that a device driver upgrade can't address? A lot of the older SD card readers were upgradable to support SDHC by using an updated driver. That was the case with my older Dell Latitude D420 and I believe the XT2 didn't originally support SDHC. It shouldn't be much more difficult than a drive overlay back when we dealt with the number of blocks on IDE and EIDE devices. There was software to get around that.
If it can't be done via software, why?
LouisCyphre
4 Posts
377
0
Posted June 26th, 2015 19:00
That's what I want. I know the SD card reader is on the USB 2.0 bus plus the transfer limitation of the hardware. I'm in it for the capacity, not the speed. If I want speed, perhaps I can use the card slot on the XT2 if such a card exists. Since my Canon Powershot S110 has WiFi and supports SDXC cards, it makes sense to use the biggest thing possible that my digital camera supports. Plus it can be used as a backup medium with a large SDXC card.

LouisCyphre
4 Posts
377
0
Posted June 26th, 2015 12:00
I have this same question. I would like to put a large SDXC in my XT2 and use part of it for a Readyboost drive.
I've been a loyal Dell customer for years. However, Dell basically turns their back on a loyal customer once the warranty expires. If my XT2 works as a spare convertible laptop running Windows 7 64-bit then I'm going to continue using it until it dies completely.
This question was asked while my XT2 was still under warranty. The warranty expired on mine last April.