
UNSOLVED
Closed
Inspiron 5150 video display
I had a short on the lower left corner that any time you press down
with your finger, the machine turns off. Decided to open it up, so I
downloaded the service manual and went to it. Moved a few things,
wiggled a few others and, what do you know, the machine boots fine,
except now the display does not work. I get no video, but I do get
video if I connect an external monitor. I must have disturbed the
power to the screen, or maybe a ground point, but where is the wire for that. Is it in the one
ribbon cable I see when I remove the keyboard and the EMI shield. This
is driving me crazy.
Responses (4)
Solutions (0)
- OK, solved one problem. The video display plug came loose. But the short remains. You are actually able to grab the machine with your fingers on the bottom of the lower left corner and your thumb on the top of the lower left corner, press the case, and the unit will shut off as if you pressed a switch. Then the unit will not restart until you pull the battery out and then reinstall it. It appears to be something shorting on the motherboard in the area of the DVD drive.
- Yup, that short is a common problem. Most likely it is in the area of the "c" panel on the bottom of the machine. If you take the cover off, you'll notice tabs on each side of the cover. One of those tabs may very well have been pressing into the motherboard until such time as an etch or component was broken - hence the shutdown. There are solutions - look around on the board for them. Apparently, a company called AQS (or something like that) in Buffalo does the repairs for these types of problem for far less money than it would cost to get a new motherboard. Of course, if it is under warranty - bug Dell about it...

ejn63
11 Legend
•
87469 Posts
•
321256 Points
173
0
Posted November 3rd, 2005 15:00
Is there any image at all on the screen (lookin very bright light for a faint image)?