UNSOLVED

MrAce

updated

20 years ago

M

MrAce

2 Intern

•

354 Posts

0

7937

September 4th, 2006 15:00

Why do you need to enable overclocking in the BIOs to simply read temps?

One question I have, since I don't overclock, is why you need to enable nTune in the BIOs (which is the same as prepping the system for overslocking) to read system temperatures?
 
I will not overclock this system.  I don't need to overclock it and I don't care about getting another 1000 3DMarks out of it. 
 
I used to overclock my self-assembled systems and it was more of a headache than anything else.  It's pizza, you cannot eat just one slice.  With overclocking, once you get the taste of higher speed, to the point that you can actually feel it during the system startup because it went 10 seconds faster, you feel the need to push it more.  At some point your system goes unstable and it all comes crashing down.  If you are luck, you just roll back the voltage, roll back the fsb, etc.  If you are a little less lucky, you have to clear the CMOS on the MBO.  If you are less lucky than that, you need to reinstall the BIOs.  If you are REALLY unlucky, you fry your motherboard -- then you say, WHY DID I DO THIS TO MY NEW SYSTEM???  I WILL NEVER DO IT AGAIN!!!
 
Okay, back to my question.  While I don't overclock, I do like to monitor system temps.  For nTune, just to monitor temps, you need to enable nTune in the BIOs.
 
I wonder if just by adjusting the BIOs selection, if Dell would assume by default that you overclocked? 
 
Intel's warranty was voided by overclocking, not because there was memory on the chip that said I WAS OVERCLOCKED, but because heat damage is pretty obvious to see and it was either caused by overcocking or a poorly installed heat sink fan...
 
What do you guys think?
 
Are there temp programs that don't require nTune to be actvitated in the BIOs???
  • supdudes

    47 Posts

    153

    0

    Posted September 4th, 2006 21:00

    Core Temp
    http://www.thecoolest.zerobrains.com/forums/viewtopic.php?t=137

    Speedfan
    http://www.almico.com/sfdownload.php