UNSOLVED

spapesh

updated

22 years ago

S

spapesh

2 Posts

0

4770

July 30th, 2004 20:00

STOP: 0x0000007B (0xF896963C, 0xC0000034, 0x00000000, 0x00000000) HELP Please!!!!

I have a Dell Dimension 8300.....

I am receiving this error after a restore of WinXP Pro. I have BIOS A06.

 

Error(Blue Screen of Death):

 

A problem has been detected and windows has been shut down to prevent damege to your computer.

If this is the first time you've seen this stop error screen, restart your computer. If this screen appears again, follow these steps:

Check for viruses on your computer. Remove any newly installed hard drives or hard drive controllers. Check your hard driveto make sure it is properly configured and terminated.
Run CHKDSK /F to check for hard drive corruption, and then restart your computer.

thechnical information:

*** STOP: 0x0000007B (0xF896963C, 0xC0000034, 0x00000000, 0x00000000)

 

  • ceri sheeran

    2 Intern

    •

    1712 Posts

    242

    0

    Posted July 30th, 2004 20:00

  • spapesh

    2 Posts

    242

    0

    Posted July 30th, 2004 23:00

    I don't believe I have anything with a SCSI interface. The original system config page on dell's site doesn't help. It is all their codes for their manufacturing process. I have not made any changes to the system since I bought it.
  • ceri sheeran

    2 Intern

    •

    1712 Posts

    242

    0

    Posted July 31st, 2004 07:00

    Hi,

    Check in Device Manager to see what is listed and post back

    The Promise ATA TX 133 card I use to run both hard disks is listed as SCSI / RAID controller.

    Ceri

  • SuperDre

    2 Posts

    242

    0

    Posted August 3rd, 2004 09:00

    I had this error during reinstalling WindowsXP, I needed to create a disk with the ATA/RAID drivers, and press F6 During setup when it was asked at the bottom of the screen, this fixed the problem for me..
  • cypherm

    1 Message

    242

    0

    Posted September 22nd, 2004 18:00

    SuperDre,  Can you tell me how to create the disk with the ATA/RAID drivers?