
Solved!
Go to SolutionGetting cmos battery out of a Precision 370
I need to replace the CMOS battery in a Precision 370 Workstation tower. When I popped the case I find out I have to remove the graphics card to get at it, which was a real treat (PCE x16,). Finally got it out, but now, I can't see how the battery comes out. Documentation suggested using my finger nails; can't get an edge up at all. tried a really thin guitar pick to lift an edge up; no dice. Does anyone have any hints.
hd
Responses (3)
Solutions (0)
You are a life saver; I could not find the above link perusing the html files for the 370 myself; I saw a doc about replacing the battery if certain error messages are obtained, and there is something that I think should be linked to the above (text would say something like "see replacing battery";
BUT, the real clincher was the idea to turn it upside down; of course, I have the big tower, and my first attempt was not too swift because the cards are not held down with screws, but this plastic bar that holds them all down, which I had not put back down after removing the graphics card. Once I fixed that , I could tilt the behemouth at an angle, then use a long wooden q-tip stem to push that metal tab back; battery fell out. Then easily pushed new battery in. Up and running. Of course, if *I* were designing the board, I would NOT have put the battery in a place that the PCE graphics card would overhang. Thank you again.

jackshack
6447 Posts
348
1
Posted September 26th, 2011 19:00
Dell's instructions are here: Replacement of the Battery (Precision 370)
<ADMIN NOTE: Broken link has been removed from this post by Dell>. If you examine the plastic holder you should see a small protrusion of plastic on one side of the otherwise circular holder. In that protrusion you should see a small metallic clip that must be pushed away from the battery to release it from the holder. Dell uses this style battery holder on a great many of its machines; If the machine is small enough it is possible to flip it so that the main board faces down, push the clip back with your fingernail, and allow the battery to fall into your hand (or onto the floor, whichever is easiest).