UNSOLVED

Razor1973

updated

18 years ago

R

Razor1973

19 Posts

0

8692

September 23rd, 2008 14:00

Dimension 5100 BIOS reporting a different speed

For a while, my friend's Dimension 5100 has been asking him to press F1 as soon as he turns it on claiming an incompatible processor was detected. This morning, he checked the BIOS and it's reporting a CPU running at 2.8 MHz when his processor is a Pentium 4 520, which should run at 3.2 MHz.

 

He did check and he has the latest BIOS version (A03).  Where could he go from here?

  • RoHe

    12 Elder

    •

    45230 Posts

    •

    172625 Points

    159

    0

    Posted September 23rd, 2008 22:00

    Did the problem start after BIOS was updated to A03? 

     

    And read this.

     

    Ron 

  • Razor1973

    19 Posts

    159

    0

    Posted September 25th, 2008 14:00


    @RoHe wrote:

    Did the problem start after BIOS was updated to A03? 

     

    And read this.

     

    Ron 


    Ron, this is very likely.  You see, about 1 year ago, I was over and he asked me to "fix" his PC, which basically consisted of the usual maintenance, uninstalling things he didn't need, removing things from the StartUp group and registry Run keys, upgrading his antivirus software and it is possible I also upgraded his BIOS to the latest one, but I really do not remember.

     

    I saw that link you posted where you recommend downgrading the BIOS to A02 (is this a known problem in A03?), but also mention "But before you do that, follow the procedure to clear NVRAM first".  What exactly does this mean?

     

    Thank you.

  • RoHe

    12 Elder

    •

    45230 Posts

    •

    172625 Points

    159

    0

    Posted September 25th, 2008 19:00

    Aren't you lucky to be your friend's tech support guru? ;)

     

    Clearing NVRAM resets the BIOS to factory default settings. It also caused BIOS to 'inventory' all the installed hardware so that it correctly recognizes all the components. If you clear NVRAM, and you don't have an internal floppy drive, you'll get a floppy driver error when you reboot. In that case, run BIOS setup and disable the floppy drive controller; be sure to save the change before exiting BIOS setup. 

     

    Don't know if this is an issue with A03, but since there are 2 posts with similar problems in the same week, it makes you wonder. A03 was released over a year ago, so it's not exactly new. And if this was a common problem, I would have thunk Dell would release another version.  I did ask the forum Moderators if this is a known A03 problem, but didn't get any responses. Guess they're all sleeping in Round Rock again. :smileytongue:

     

    Ron 

  • Razor1973

    19 Posts

    159

    0

    Posted September 28th, 2008 12:00

    Well, Dell better look into this one, cause it certainly sounds about a bug with A03.  My friend downgraded to A02 and the problem is gone.  I am marking your post as the solution.

     

    Thank you!

  • RoHe

    12 Elder

    •

    45230 Posts

    •

    172625 Points

    159

    0

    Posted September 29th, 2008 20:00

    :)