Alternatively, does anyone know how I can obtain this SSD shield? The proper SSD shield was not included in my most recent purchase (8/3/2020) of a Latitude 9410 (upgraded from 1 TB to 4 TB). A small shield was included with my laptop that is big enough to shield the 1 TB SSD, but when upgrading to the 4 TB SSD, the 4 TB drive is much longer and therefore requires a longer shield. Dell clearly makes a much longer (bigger) shield because it is seen here in the Dell sponsored video that demonstrates how to change the SSD. I just need to know how to get my hands on this particular bigger SSD shield rather than the smaller shield that comes with the 1 TB SSD in the 9410.
OK, I finally got my larger shield after a lot of run-around and placed the 4TB drive in the Latitude 9410, turn it on and the computer does nothing. When I attempt to use the recovery stick to reload windows, it says in green letters in the upper right hand corner that is entering the boot menu, but then in hangs (> 20 min). Then I simply tried to get into the bios... again, I get the dell logo, press F2 and it says in the upper right hand corner that it is entering bios, but then it hangs a never enters the bios. When I replace the 256 TB drive back into the laptop, it works fine and I can get into windows and the bios. I went back and updated the bios on using the 256 drive and then replaced the 4TB drive into the slot and same outcome: can't get into bios and it hangs at the dell logo screen. So then I took the 4 TB drive and placed it into a separate older Dell Precision 7710 that I have (also not a completely functioning computer - LCD problem that warranty is working on - now at depot), but when the 4TB drive was placed into the Precision system, the bios recognized the 4TB drive just fine. So probably not a drive problem. I double checked the outer pins on each drive... both 5 pins in the smaller set for both the 256 and 4TB drives. So then I called Dell Pro Support and went through this same troubleshooting and could never get to the point where we could enter the BIOS.
As such, Dell agreed to send a new replacement (as this 9410 is brand new). I don't have the new Laptop here yet, but here is my concern. It is my guess that when I receive this new computer, it will do the same thing when I place the 4 TB drive into the slot. Everyone, including the initial Dell Sales Rep (Mike) as well as the multiple Pro Support Plus Reps have assured me that a 4 TB drive (and an 8TB drive if I wanted to go that big) will fit and is compatible with the system. I mentioned that on their website, it does not specify that a 4TB drive can be used (only up to 2 TB), but they still have all assured me that the 4 TB drive is compatible with the system. I am skeptical that this is the case. I have looked online for compatibility information, but have found none. Can anyone at Dell confirm that a 4 TB drive can be place into the system? Dell made me buy the 4 TB drive from them otherwise they said it would void the warranty, but I don't think that the 4 TB drive they sent me is compatible with this system, which is the whole reason I purchased the system. Can anyone confirm the the 4TB drive that was sent to me is compatible with the system? It is a VisionTek SDD M.2 NVme 4TB PCLE drive with part number 901364.
Has this problem with the 4TB in a Dell 9410 been solved?
I am desperately trying to get an 8TB M.2 SSD to run. In the overview page in the BIOS, I can see the SSD (reports as 8001GB), but it does not show up in the list of drives afterwards. The old 2TB shows up there when installed, but the field is just empty when installing the 8TB.
ejn63
12 Elder
•
31863 Posts
•
156334 Points
691
0
Posted August 9th, 2020 03:00
The only place you'll get one is Dell Spare Parts.
in the US,
1-800-357-3355