I want to buy an ssd. The model is Samsung 960 evo, Nvme ssd. Here is link: https://www.amazon.com/gp/aw/d/B01LYFKX41/ref=ox_sc_act_image_1_1_1?smid=ANNSJU9W28Y9J&psc=1 My laptop model Dell Inspiron 5570. s.n:gp05zl2 My question is can i use this ssd on my laptop. In my manual, it is written only that technology of ssd is m2 pcie, this ssd is pcie port 3*4. I can't figure out will it support my model or not? Help is needed
Ejn63 is correct. In addition to NVMe slots being wired for x2 or x4 PCIe, they can also be run in max performance or power saving mode, and this unfortunately is typically not user-configurable and not mentioned in specs. An x4 interface running in power saving mode is roughly equivalent in performance to an x2 interface running in max performance. If your system is set up for power saving mode, NVMe SSDs will be limited to about 1.8 GB/s. That’s still a lot faster than SATA SSDs, which top out around 550 MB/s, but don’t expect to see the SSD’s full 3 GB/s that you might see in benchmarks that were performed in other systems.
There is no way you'll get performance mode from any NVMe drive. It will still be faster than SATA -- but the system is not designed to run in full-out performance mode. For that, you need a higher-end XPS or Alienware system.
There are two modes in which NVMe drives can be run -- one for power economy and low heat generation (which yours is hardwired for) and one for all out performance (which you'll find in an upmarket system).
Yes. Any NVMe SSD that can deliver more than 1.8 GB/s will be bottlenecked by that system, but I personally would still rather have an NVMe SSD than a SATA SSD and I’m a fan of Samsung, so I would still buy a 970 Evo even if I couldn’t get all of my money’s worth out of it.
jphughan
11 Legend
•
13985 Posts
•
79931 Points
24833
0
Posted August 11th, 2018 09:00
Ejn63 is correct. In addition to NVMe slots being wired for x2 or x4 PCIe, they can also be run in max performance or power saving mode, and this unfortunately is typically not user-configurable and not mentioned in specs. An x4 interface running in power saving mode is roughly equivalent in performance to an x2 interface running in max performance. If your system is set up for power saving mode, NVMe SSDs will be limited to about 1.8 GB/s. That’s still a lot faster than SATA SSDs, which top out around 550 MB/s, but don’t expect to see the SSD’s full 3 GB/s that you might see in benchmarks that were performed in other systems.