So I added a Noctua NF-B9 redux-1600 PWM fan to the 4 pin header for the front fan. Well it suppose to be 1600 RPM and CPUID HWmonitor is reporting it running at a whopping 500 RPM. What gives? should the motherboard be able to control this? how can I find out. When I ran the diagnose program after hitting F12 It runs a test on the cpu fan and the rear fan never tests the front. Whats going on?
EDIT. Pin colors on the Noctua are as follows Pin 1: Black : ground Pin 2: yellow : 12V postive Pin 3 : Tach signal Pin 4 : PWM Signal The rear case fan has the wires as follows Pin 1 : Black Pin 2 : Red Pin 3 : Yellow Pin 4 : Blue.
Dell doesnt allow for PWM fan control unless its a dell OEM fan. And even then you have no manual control over the fans, its controlled by the bios/UEFI
If you want a faster fan in the front get the antec tri-cool 3 pin fan with the 3 speed switch that will allow you to manually select a speed or use a sata powered pwm controller with a speed dial not plugged into your mobo fan header. Thats about all you can do. If you remove the rear fan you will get a startup fan error, some people have successfully replaced the CPU cooler and fan with no issues or warnings but thats also not guaranteed.
I actually solved it today. I purchased a fan hub on amazon, Its a 10 fan hub that connects to sata power. It has a 4 pin but only the RPM wire and pwm wire connected to the rear fan header on the board. Fan one on the controller is what the computer looks at and it is the rear fan. Then I have the noctua front fan on the next slot over. Works great now. Computer still sees the dell fan and when it speeds up, the noctua does too.. Why dell does this I'll never understand.
slosaab
1 Rookie
•
18 Posts
2815
1
Posted July 16th, 2019 18:00