UNSOLVED

kzhao19

updated

12 years ago

K

kzhao19

10 Posts

0

242646

October 30th, 2014 18:00

Failure of downloading update package to managed servers

Hi

Had problem to push out firmware update to multi hosts through OME.

Below is the error report, it seems the download link given to the target host missing OME server’s IP address??? – apparently " http://:1278 " is not a full meaningful IP Address presented to hosts.

I can download the update file by using a FULL OME server's IP address like "http://x.x.x.x : 1278/xxxxx"

Results: 

 Downloading Packages.

Calling InstallFromUri method to Download packages to the iDRAC

 Downloading Package: Network_Firmware_NF92Y_WN32_7.10.18.EXE onto the iDRAC

 Package download has successfully started and the Job ID is JID_146034109453

The URI given to the iDRAC to download from: http://:1278/install_packages/Packages/Network_Firmware_NF92Y_WN32_7.10.18.EXE

Downloading Package: Diagnostics_Application_7PGR2_WN32_4241A0_4241.1.EXE onto the iDRAC

 Package download has successfully started and the Job ID is JID_146036587505

The URI given to the iDRAC to download from: http://:1278/install_packages/Packages/Diagnostics_Application_7PGR2_WN32_4241A0_4241.1.EXE

 

Checking the Status on the following Job(s): JID_146034109453

Checking the Status on the following Job(s): JID_146036587505

The JOBID JID_146034109453 has failed with the following message:

The specified URI is invalid.

MessageID: RED005

The JOBID JID_146036587505 has failed with the following message:

The specified URI is invalid.

MessageID: RED005

Download Error occured. 

 Package Network_Firmware_NF92Y_WN32_7.10.18.EXE failed to download on target device.

 Package Diagnostics_Application_7PGR2_WN32_4241A0_4241.1.EXE failed to download on target device. Update failed.

Software Update Task Failed.

  • DELL-Pupul M

    2 Intern

    •

    1004 Posts

    5532

    0

    Posted October 30th, 2014 22:00

    You can also check if this post helps you:

    http://en.community.dell.com/techcenter/systems-management/f/4494/p/19601242/20691098#20691098

  • DELL-Pupul M

    2 Intern

    •

    1004 Posts

    5532

    0

    Posted October 30th, 2014 22:00

    Hi,

    Is IPv6 is enabled in your network? If yes, can you disable it and try again?

  • kzhao19

    10 Posts

    5532

    0

    Posted October 30th, 2014 23:00

    No IPV6,


    Yes, have already checked the link, added hostname and ip address into hosts file, didn't make any difference.

    Uninstall/Reinstall twice, same error -  no IP Address given to DRAC to download.

  • DELL-Pupul M

    2 Intern

    •

    1004 Posts

    5532

    0

    Posted October 31st, 2014 03:00

    Which is the OS where your OME is installed?

  • kzhao19

    10 Posts

    5532

    0

    Posted November 1st, 2014 22:00

    It's 2012 R2.
    The problem occurred after chang IP address of OME server.

    I did re-discovery and inventory, worked ok but update task always failed.

    I found problem may be related with IIS, seems it can't publish download link correctly.

    Thanks.

  • DELL-Pupul M

    2 Intern

    •

    1004 Posts

    5529

    0

    Posted November 2nd, 2014 21:00

    Well, i am running out of suggestions. Can you create a support ticket so that the support guys can look into it? The support number is 800-945-3355.

  • DELL-Rob C

    4 Apprentice

    •

    2843 Posts

    5529

    0

    Posted November 7th, 2014 12:00

    Hi, thanks for the question.

    So, do you have IPv6 enabled?  Most of the folks who run into this and disable IPv6 see it resolved.  So do review this and the referenced thread.  If not IPv6, then we can look at a few other things.

    Thanks much,

    Rob

    delltechcenter.com/ome

  • DELL-Rob C

    4 Apprentice

    •

    2843 Posts

    2041

    0

    Posted November 7th, 2014 12:00

    Ok, so I don't think you have to restart OME, but if you did, there is a restart OME services button in the OME preference screen.

    Anyway, at a minimum you can right click on the server and re-run disc/inventory, but you might even be able to get away with out doing that.  I think when you run the patch task it makes a GetHostIP call to windows, so I expect you can just give it another go.  

    Thanks,

    Rob

  • marzlarz

    24 Posts

    5529

    0

    Posted November 7th, 2014 12:00

    Rob,

    I did have IPV6 enabled. Once disabled, do I have to restart OME? If so, how does one do that? ( not a windows admin ) :) 

    Thanks!

  • marzlarz

    24 Posts

    5529

    0

    Posted November 7th, 2014 12:00

    I am experiencing the exact same issue. Did you ever get this resolved? I currently have alot of servers in OME and no firmware updates can be applied.

    Thanks!