UNSOLVED

markwragge

updated

18 years ago

M

markwragge

71 Posts

0

1134

December 16th, 2008 08:00

default ip address of ax100

Hi, I am attempting to initialize a new ax100 (dell/emc) array. I have powered on the system but do not know the default IP address of the SPs. I have been looking through documentation but none of it states the exact defult IP address. Could someone let me know te default ip address and subnet mask?

Thanks for any help
  • DGM3

    238 Posts

    312

    1

    Posted December 16th, 2008 19:00

    Mark,
    There are a couple prior threads on this topic, which may be helpful;
    http://forums.emc.com/forums/thread.jspa?threadID=82450
    http://forums.emc.com/forums/thread.jspa?threadID=85292

    Also see the AX-series support site;
    http://www.emc.com/microsites/clariion-support/ax100/support.esp
    There is a FAQ there ("Common technical questions") that may also be helpful.

    Regards,
    DGM
  • markwragge

    71 Posts

    312

    0

    Posted December 17th, 2008 01:00

    thanks for this info. I have had a good look through the documentation but could not find the IP address and Subnet listed anywhere. Thanks for the Ip address but my understanding is that i need to have the correct subnet to successfully use navisphere initialization utility.

    do you know the subnet that should be used.
  • bertog

    61 Posts

    312

    0

    Posted December 17th, 2008 10:00

    Hello Mark,

    The Navisphere Storage System Initialization Wizard will discover any non-initialized AX and CX series arrays when run from a server on the same physical subnet. The initial IP address is typically set to 1.1.1.1 so as not to conflict with anything else on the network, but you should not need to change anything on your server for the init wizard to work. The server must have IP ethernet connectivity to the storage processor (or both if a dual SP model), the utility will find the arrays and allow you to set the ip addresses of the management ports, as well as configure the management security. The wizards can be downloaded from Powerlink:
    Home > Support > Software Downloads and Licensing > Downloads C >
    CLARiiON Navisphere Host Based Agent/CLI Linux
    or
    CLARiiON Navisphere Host Based Agent/CLI WindowsNT/Windows 2000 and 2003


    Does that answer your question?