UNSOLVED

osu78

updated

21 years ago

O

osu78

6 Posts

0

5957

January 29th, 2006 01:00

Critical Media Center failure

I just installed a hauppauge PVR-150 in my E-150. It installed fine, I updated the drivers and setup Media Center  (even pulled in the guide for my local cable area).  However, when I try to click on a channel I get the following error "A critical media center process has failed.  Please restart the computer (which I did several times) and try again.  If the problem persists contact your hardware manufactuer for assistance.  Tried that to.  Basic dell support couldn't help so they transferred me to the Advanced Media Center dept which of course was closed now and I was cut off.  Can anyone else help me?
 
thanks!
 
osu78
  • Mary G

    6 Operator

    •

    20095 Posts

    73

    0

    Posted January 31st, 2006 17:00

    Did you get the correct hauppauge MCE updated drivers? Here's the site: http://www.hauppauge.com/pages/support/support_mce.html
    Did you get the Wintv 150 pvr special version for MCE? Check with the Wintv support site.

    Message Edited by Mary G on 01-31-2006 03:06 PM

  • osu78

    6 Posts

    73

    0

    Posted January 31st, 2006 22:00

    Did you get the correct hauppauge MCE updated drivers? Here's the site: http://www.hauppauge.com/pages/support/support_mce.html
    Did you get the Wintv 150 pvr special version for MCE? Check with the Wintv support site.

    Message Edited by Mary G on 01-31-2006 03:06 PM

     
     
    Mary G, yes to both.  I have the updated drivers installed and I got the WinTV 150 PVR MCE Version.  For some reason the problem seems to center around .net version 2.0.  If I force the system to boot up with version 1.0 the card works fine.
     
    Steve E (osu78)