Who has SUCCESSFULLY installed a HDD > 137GB in a Dimension 8200?
I've just ordered a 200GB hard drive...dunno if I have enough time to cancel it now...
Do hard drives > 137GB work in Dimension 8200 with or without BIOS updates, all of the time, some of the time, or never...?
Surely if at least one person replies to this topic saying they've done it successfully, does this mean it will work in all cases, if not, does anyone know why?
Thanks, and by the way, I am NOT talking about using an additional PCI card or anything, without one only.
I just installed a WD 160 GB in my D8200.You can install any size into the D8200 providing that you run WinXP with a SP 1 or 2.You have to have one or the other of this Service Pack otherwise the limit that WinXP recognize is 137 GB.
I just installed a WD 160 GB in my D8200.You can install any size into the D8200 providing that you run WinXP with a SP 1 or 2.You have to have one or the other of this Service Pack otherwise the limit that WinXP recognize is 137 GB.
I've done it. I have a 200GB as the slave. Prior to purchasing the HD, I had already did a BIOS upgrade. I didn't do the upgrade just because I was going to buy a new HD. The sale on the HD was good, thus I bought it regardless of the status of my BIOS (which just happen to be the latest version).
So pending any BIOS issues, it should work--at least for me it did.
Okay, so it seems some people have done it successfully... The reason I asked is because I've also seen people say that no matter what they tried it wouldn't work, and they were forced to buy a PCI card. I was worrying that perhaps some of the older Dimension 8200's didn't work with the bigger drives, or maybe some models have slightly different IDE controllers or something. I certainly hope that all Dimension 8200s will work just as nicely as yours has with accepting the bigger drives no problem.
Is there a reason you would not be able to install your 200 as the master, and an older (smaller) HD as the slave?
I don't see any reasons why you couldn't do the reverse of my setup. It should work either way. Just be sure to check your jumpers and cables, that's all.
Well I just installed my 200GB hard drive successfully in my system. :D It shows up in Windows as having a 186GB capacity, so I guess all things are as they should be.
One thing I should ask though is I my 200GB is on the same IDE channel/cable as my 120GB hard drive... I've been told it's best not to have the two hard drives no the same channel, but the problem is it looked pretty difficult to put my new HDD onto the other IDE channel...cable wasn't long enough or the hard drive would only fit it one of the bays or something...maybe a limitation of the Dell case or something that I can only fit a new hard drive next to the original one. Anyone know if there is way, or understand what I mean? On the other IDE cable/channel I have my CD-RW and DVD drive.
george_c 40
233 Posts
250
0
Posted December 1st, 2004 18:00