I have a older dimension 8200, I have both a CD read only and a DVD rewrite drive. One day, the CD drive just stopped working. It does not read any CD I put in it, I also do not hear the drive spinning anymore. Is there a easy way to tell it the "Drive" has failed or if it is a driver issue? If so, is it hard to replace just the drive? Any suggestion would be greatly appreciated.TIA
Easy test for covering the drivers: click on the CD/RW link in my post and scroll to Section 15, article 1; Section 20, article 3. Dell has a couple of articles to test the drive; same CD/RW link; Section 12, article 3.
To replace the drive, a good habit, first go to Device Manager, select the drive you are replacing and click Uninstall, shutdown. Dell uses the Cable Select jumper settings, so set the new drive to cS, not Master or Slave. Here is the Dell User Guide for your 8200 series
Best Regards!
God, grant me the senility to forget the people I never liked anyway, the good fortune to run into the ones I do and the eyesight to tell the difference. CD/RW Link
I am having the same problem, but my system is the Dimension 4300s. My CD just stopped. Whenever I try to use it, my system tells me "drive not installed".
Please go ahead and try the same steps I listed above. These are fairly standard steps to use for trouble shooting and let us know the results. Thanks...
Best Regards
God, grant me the senility to forget the people I never liked anyway, the good fortune to run into the ones I do and the eyesight to tell the difference. CD/RW Link
God, grant me the senility to forget the people I never liked anyway, the good fortune to run into the ones I do and the eyesight to tell the difference. CD/RW Link
It worked! The first time I rebooted after uninstalling, the secondary IDE had the yellow mark, so I uninstalled it and rebooted again. This time when my computer came up, it said my modem was there in all its glory!!! Thank you so very much. FYI, it was section 20, article 3 that helped the most. Thanks again.
Predator
2 Intern
•
15286 Posts
570
0
Posted July 4th, 2006 20:00
Hi Yakon,
Easy test for covering the drivers: click on the CD/RW link in my post and scroll to Section 15, article 1; Section 20, article 3.
Dell has a couple of articles to test the drive; same CD/RW link; Section 12, article 3.
To replace the drive, a good habit, first go to Device Manager, select the drive you are replacing and click Uninstall, shutdown. Dell uses the Cable Select jumper settings, so set the new drive to cS, not Master or Slave.
Here is the Dell User Guide for your 8200 series
Best Regards!
God, grant me the senility to forget the people I never liked anyway,
the good fortune to run into the ones I do and the eyesight to tell the
difference.
CD/RW Link