I recently bought XPS 8300 which came with 1TB SATA HDD. There is one DVD burner. I added another 1.5 TB HDD. This setup had been working correctly. Yesterday I added another Western Digital Green 3 TB SATA HDD. Following is the current setup:
SATA Port 0: 1TB HDD (Primary) SATA Port 1: 3TB HDD (New) SATA Port 2: 1.5TB HDD SATA Port 3: DVD drive
Since I've attached new 3TB, under disk management, it is only displaying 746GB instead of 3TB.
How can I have my system detect 3TB instead of only 746GB?
I did update Intel RST and after reboot Disk Management was able to recognize entire size of the hard disk. But the problem that now I face is that there are two volumes of that 3TB HDD. One is for 2GB while the other is 746 GB unallocated.
How can I use the unallocated volume (746 GB) along with 2GB and have only one partition for the entire 3TB HDD? Also upon right clicking on the 746 GB, all the options are grayed out.
I did update Intel RST and after reboot Disk Management was able to recognize entire size of the hard disk. But the problem that now I face is that there are two volumes of that 3TB HDD. One is for 2GB while the other is 746 GB unallocated.
How can I use the unallocated volume (746 GB) along with 2GB and have only one partition for the entire 3TB HDD? Also upon right clicking on the 746 GB, all the options are grayed out.
osprey4
6 Operator
•
34230 Posts
751
0
Posted July 10th, 2012 16:00
Hi Adnan,
This problem can be addressed by updating to the most recent Intel RST.
Good luck!