UNSOLVED

Mendocino

updated

12 years ago

M

Mendocino

59 Posts

0

2505

June 4th, 2014 02:00

RecoverPoint Deployment Manager fails to connect to VNX

We want to connect 2 RPAs to a VNX (within a VBlock).

I tried to run Deployment Manager to configure the RP Cluster.

DM fails at the point where I give the VNX login credentials with the message:

"Failed to set the given VNX/CLARiiON credentials".

From the same server I'm able to connect to the VNX using Unisphere so I assume IP connectivity is ok.

Any ideas?

Thanks

Dieter

  • forshr

    2 Intern

    •

    1126 Posts

    1095

    0

    Posted June 4th, 2014 04:00

    Try to telnet from the DM workstation to the VNX SP IP addresses.

    Rich Forshaw

    Consultant Corporate Systems Engineer - RecoverPoint & VPLEX (EMEA)

    Data Protection & Availability Division

  • 1095

    0

    Posted June 16th, 2014 23:00

    Hello Rick

    I have exactly the same issue.

    I cannot telnet or  ssh to the SP that is the domain manager but I can login via a browser.

    VNX5400 has the recoverpoint enabler installed.

    VNX Block OE is 5.33.000.5.052

    RPA has been upgraded as part of the initial setup to 4.0SP2.P1

    Thanks for any assistance

    Rob

  • forshr

    2 Intern

    •

    1126 Posts

    1095

    0

    Posted June 17th, 2014 14:00

    Are there any special characters in the password being used?

  • 1095

    0

    Posted June 17th, 2014 15:00

    no special characters - sysadmin/sysadmin

  • forshr

    2 Intern

    •

    1126 Posts

    1095

    0

    Posted June 19th, 2014 08:00

    Check vlan conectivity between the two including port restrictions due to firewall.