UNSOLVED

dell r750

updated

8 days ago

DR

dell r750

1 Message

•

4 Points

0

24

November 12th, 2026 06:54

PowerEdge R750: CPU2 not detected after cross-socket test; system stalls at POST and powers off

CPU2 is not recognized in BIOS/iDRAC. I ran a cross-socket test:
- CPU1 moved into the CPU2 socket: still not detected.
- CPU1 in the original CPU1 socket: recognized normally.
- Original CPU2 installed: the system stalls at the POST/self-test screen and powers off after a short while.

I also swapped the good CPU1 heatsink and retention clip onto CPU2, but CPU2 remained undetected, so the heatsink itself is not the cause.

Additional notes:
- The CPU2 heatsink clip/screw was found damaged and was not seated flat; memory is installed in the CPU2 (B-channel) slots.
- iDRAC SEL reports CPUA0023 "CPU 1 is absent" and "Config Missing: CPU2".

Question: Does this confirm CPU2 itself is faulty, or could the CPU2 socket / mainboard channel also be bad? What is the recommended next step before replacing the CPU?

(edited)

No Responses