UNSOLVED

nabhijeet

updated

19 years ago

N

nabhijeet

1 Message

0

6251

February 16th, 2004 09:00

PowerEdge 1600 - Does not boot after IDE and CD-R are attempted to be installed

System Config:

PowerEdge 1600SC ==>CPU: Xeon 2.8 GHz, RAM: 1.5GB, HDD: 36 SCSI320, CDR: 1 cd-rom

Action that caused the problem:

1. Added  a CD-RW drive to the same cable that goes to the CD-R drive

2. Added a 20GB IDE drive to restore some data. IDE drive was connected to on-board primary IDE.

Problem description:

System does not boot i.e it does not go to the point of loading OS. This happens even after I have removed the new hardware that was attempted to be added.

Observations:

a. On booting, the LSI configuration utility is unable to verify or format Fujitsu MAP3367NP

b. As soon as the server is powered up, a clicking/chugging sound keeps coming from the SCSI drive

c. Cannot enter System mode, since the system 'hangs' at  'Searching for device at HBA 0, ID 0, LUN 0'

 

I have searched and read a lot of forum articles. Do I need to reset the SCSI bios? ..if so, how? Has the SCSI HDD got shot somehow? Please advise. TAG: 9Z1Q641

  • DELL-Mark A

    2 Intern

    •

    2521 Posts

    125

    0

    Posted February 16th, 2004 15:00

    Hi,

    I see you have already called into technical support for a replacement hard drive. I would highly recommnend checking each cable connection for bnet pins or other damage which might have led to the hard drive failure.

  • 125

    0

    Posted July 13th, 2007 09:00

    Please check:

    http://www.dellcommunity.com/supportforums/board/message?board.id=pes_bios&message.id=2752#M2752

    Message Edited by CorneliusMostert on 07-13-2007 05:45 AM