LACP group doesn't work with 2 stacked DELL PC 6248 and 2 ESXi 5.5
I would like to use the LACP/LAG feature in vSphere 5.5. So I created a new vDS and an LAG group. 2 NICs per host should be use for that. We use 2 hosts, so in total 4 ports are involved. Basicly you can view a scheme at vmwares KB article 2051826 (http://kb.vmware.com/selfservice/microsites/search.do?language=en_US&cmd=displayKC&externalId=2051826)
Problem is only 2 of the links in lacp group are active, while the other 2 are inactive. Active is only one of the esx hosts, it depends which ports are going to be active first.
Any advice? Anyone have a config like that working?
Best regards,
Alex
Relevant config for switch:
!Current Configuration: !System Description "PowerConnect 6248P, 3.3.7.3, VxWorks 6.5" !System Software Version 3.3.7.3 !Cut-through mode is configured as disabled stack member 1 5 member 2 5 exit configure
interface ethernet 1/g8 channel-group 3 mode auto description 'ESX2_vmnic5' spanning-tree disable switchport mode general switchport general ingress-filtering disable switchport general allowed vlan add 20 tagged exit
interface port-channel 3 description 'ESX' hashing-mode 6 spanning-tree disable switchport mode general switchport general ingress-filtering disable switchport general allowed vlan add 20 tagged exit
The secret is you have to create a separate group on the switch for every esx-host. On the esx side you have the config with one lacp/lag group. But on the side of the switch you need 2 groups for two hosts. VMware should have made this more clear I think.
Is port 1/g8 the only port in the port channel, or did you do a similar config for all 4 ports? Are the ports showing inactive on the switch or ESX side?
On ESX Side the Host with the inactive ports shows an error of course. Like I said, if I remove one host from the config, the ports of this host are up, tested both Hosts, but with two hosts, one is always inactive.
Thanks for the additional information. Can you try to shutdown and no shut the ports that are showing inactive? It will show ports as inactive when they are not connecting. Is the VDS lacp mode set as active or passive? You might want to try the other mode.
Already tried to shut down the ports. active / passive on VMware side has no effect. At the moment I have an DELL engineer who is working with me on that problem. I'll post an update as soon as I have new things or the solution to tell. I hope he finds a solution.
Alexander_Busch
1 Rookie
•
12 Posts
2581
0
Posted October 28th, 2013 06:00
Thanks to the good Support at DELL.
The secret is you have to create a separate group on the switch for every esx-host. On the esx side you have the config with one lacp/lag group. But on the side of the switch you need 2 groups for two hosts. VMware should have made this more clear I think.