UNSOLVED

hrzr

updated

12 years ago

H

hrzr

4 Posts

0

32303

December 3rd, 2014 00:00

Dell N3024 connect to Cisco 3560E with vlan, Vlan is not updated to Cisco

Hi all,

We are in progress to connect switch N3024 to our core switch Cisco 3560E with vlan. We will need a vlan 192 on N3024 along with Cisco 3560E.

From N3024 we applied configuration for primary/secondary uplink to Cisco  3560E switch ( create vlan on this switch):

vlan 192
name "LON_ISCSI_VLAN"
exit
vlan 192
exit

interface Gi1/0/24

Des "uplink port to primary Cisco"
switchport mode trunk
switchport trunk allowed vlan 192
exit

interface Gi2/0/24

Des "uplink port to secondary Cisco"
switchport mode trunk
switchport trunk allowed vlan 192
exit

Cisco 3560E Primary/Secondary switches:

interface GigabitEthernet0/1

description "up to Dell SWC2 PT24"
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 192
switchport mode trunk
switchport nonegotiate

But when i show vlan on Cisco, there was no vlan192 updated from Dell to Cisco, we have the same configuration in other site but everything works well.

The question is ... how to make Cisco updated Vlan192 ? or do i have to create vlan192 again on my Cisco switch ?

Thanks

Hrzr

  • DELL-Josh Cr

    Community Manager

    •

    9790 Posts

    •

    45217 Points

    1496

    0

    Posted December 3rd, 2014 10:00

    Hi Hrzr,

    Is VLAN 192 created om the Cisco switch. Your configuration looks correct on the N3024. Is the iSCSI traffic tagged? If you assign an IP address to the VLAN on the N3024 can you ping it from devices attached to the Cisco switch?  

  • hrzr

    4 Posts

    1496

    0

    Posted December 3rd, 2014 19:00

    Hi Josh,

    We didn`t create any vlan on Cisco side last day, there was no tag on uplink ports as well. All uplink port s are in Trunk mode, allow trunk vlan 192.

    Yesterday, I created the vlan on Cisco then it works for us ..... Normally, we just use Cisco with VTP located on server Cisco ... Vlan between Cisco/Dell to Sites work for us so far.

    But i`m not happy with the speed as ping with TTL <=1ms, we assigned the ip address to VLAN on our Colt`s MPLS router, it that a reason for TTL = 1ms ? ( Colt router connects to Cisco Core switch==> Cisco Core connects to Dell N3024 ==> connects to Vlan host)

    A question, is it ok with your view if i migrate the IP Address of Vlan from Colt`s router to Dell N3024 to optimize speed ?

    Thanks very much for your support

    Hrzr

  • DELL-Josh Cr

    Community Manager

    •

    9790 Posts

    •

    45217 Points

    1496

    0

    Posted December 4th, 2014 08:00

    VTP is a Cisco proprietary technology, so any connection to our hardware will require manual VLAN entry. Migrating the IP address should be fine.