For past few weeks LTO3 tapes are not being marked "expired" automatically. When I check in NW GUI - Media - Volumes: expiration column is empty for these LTO3 tapes. ALL the savesets for these tapes say "recyclable" - but I have to manually make the tapes "recyclable". This applies to all the tapes from different pools.
We have already ran nsrck -L6 and nsrim -X. Not sure what else we could try.
You have dependent savesets. To explain this say you have a backup at level full at the start of the week and other days you do an incremental, and all backups have a 1 week retention. After a week the full backup reaches its retention point so we would expect it to expire, right? But we also need to think about our incremental backups - the incremental backup is not an entity on its own but one that taken with previous incremental and full backups makes a backup of the system at that time. Your backup taken the previous day on the last day of the week still has 6 days to run until expiration, but you need to take into consideration for expiration the previous backups made which that incremental backup depends on, which includes our full backup we believe should have now became recyclable, but obviously cannot be as it also makes up a part of backups yet to expire.
Marking the tape as recyclable does not definitely mean it will be overwritten, but if it does get overwritten you will find you cannot recover your backups from the end of the week within the retention period you expected.
I've just re-read your post. You state all the savesets are recyclable, if that is the case you would expect to have the tape become recyclable. This may be similar to a bug I have seen recently (3 months back but I am still waiting for the muppet at EMC to understand it). Try this:
Take one of your tapes, check in the GUI that all savesets say recyclable. At the command line type mminfo -mq volume=volumename and ensure all savesets are recyclable there too.
Next at the command line type nsrim -V volumename - this will examine all the savesets on the tape which may produce a lot of output for maybe up to a minute. At the end it will give a summary of what is on the tape, what savesets are recyclable and what are not. For the bug I saw there were additional savesets summarized that were not shown either in the GUI or mminfo output. The problem affected a small percentage of our tapes then went away, but it is worrying that backup data may not be recoverable (since we are unable to establish what the data was it was not possible to ascertain whether the data would be known to the recover operation).
David - I had to manually mark it "recyclable" with other 15 same tapes that I have to mark recyclable manually everyday. All these expired tapes are still NOT being marked properly.
Check the state - you are looking to see if the volume is set to E for expired; you are looking to ensure the volretent value has been exceeded, you can also check the saveset information to ensure all savesets have passed their retention and are expired.
Next run nsrim -V volume again, see if it again indicates it is setting the volume to be recyclable.
Finally run the mminfo command again and see what changes we see...
May be you have set your volumes as manual recycle.
A volume that has been set to manual recycle retains that setting, even after relabeling. A Manual Recycle policy cannot be changed back to Auto Recycle simply by unselecting the Manual Recycle checkbox. The volume must be explicitly reset to use auto recycle.
DavidHampson
2 Intern
•
1080 Posts
829
0
Posted September 3rd, 2009 01:00
Marking the tape as recyclable does not definitely mean it will be overwritten, but if it does get overwritten you will find you cannot recover your backups from the end of the week within the retention period you expected.