UNSOLVED

maledd

updated

20 years ago

M

maledd

8 Posts

0

7175

March 6th, 2007 17:00

Dell 2007WFP stuck in "entering power save" on DVI

Hi,
i recently purchased Dell's 2007WFP panel. It is rev. A02, firmware:V1B11. On VGA everything works perfectly. However when I switch to DVI mode there is nothing displayed both during BOOT (DOS) and in windows - monitor continously reports "entering power save". Graphics card is Sapphire X800GTO - i've never got problems with DVI before. Doing some reserach on other machine (ATI 9000 AGP) i've manged to see display during BOOT and windows but only with standard VGA drivers. However testing with nVidia Ti4500 AGP DVI works fine. Using then EnTech's PowerStrip application to check monitor it reports "No DCC info avaliable" when reading EDID directly from monitor. Also windows cannot recognize monitor as a plug&play device on DVI and showing nothing under device manager. I already go through so called "procedure" of switching off monitor, computer, discontecting power cables and switching on again a few times - no results.  Anybody have idea what's going wrong? Help appreciated.



Message Edited by maledd on 03-06-2007 01:28 PM
  • Pat1

    176 Posts

    303

    0

    Posted March 7th, 2007 03:00

    I have two 2007WFP monitors, one on a XPS Gen4 with a ATi X850 XT PE, the other on a 8100 with a ATi 8500. If I use a DVI cable on the 8100, I don`t get anything on screen until the desktop loads, if I use VGA cable I can see everything(dos) at bootup. On the XPS Gen4 I see everything no matter what cable I use.
     
    I have switched the monitors on the two computers but the results stay the same. Therefore I don`t think there is a problem with the monitor. That is just how it is with older hardware and it is really not a problem and the picture is fantastic on either cable. I have even had both cables hooked up at the same time and used the input button on the front of the monitor to switch back and forth without any problems.
  • maledd

    8 Posts

    303

    0

    Posted March 7th, 2007 12:00

    fine. but in my case, i've got problems with NEWER card. in fact there is a little differnce in quality between VGA & DVI with this monitor. however I would like to be sure either my monitor or card is faulty in some way. Maybe someone has experience with Sapphire X800GTO and Dell monitors?