UNSOLVED

Tami Mc

updated

22 years ago

Closed

TM

Tami Mc

1 Message

0

10788

November 26th, 2004 16:00

Latitude D600 will not power on when computer is not in the docking station

Note -- this laptop is one month old.
 
A number of users have a similar issue.  50% of the time when the laptop is not in the docking station, it will not power on.  Green light comes on, but nothing -- no sound, no screen, etc. 
 
Popping out the battery and DVD/CD did not work.  Removing the hard drive, then powering on worked.  Functioning like this, however, is not acceptable. 
 
Dell - why does this occur and what is your permanent fix?
 

 
  • DELL-Corey

    1 Rookie

    •

    2570 Posts

    314

    0

    Posted November 29th, 2004 11:00

    Tami Mc,

    Thank you for using Dell's Community Forum.

    As a test, I would try tightening the screws found on the bottom of the computer.
    If that does not help, you may have something wrong with the connection to your motherboard.
  • menlo

    3 Posts

    314

    0

    Posted November 30th, 2004 16:00

    We're having the same problem.  The D600 won't power on using the button at the front of the monitor stand but will if you reach under and use the button on the port replicator. 
  • DanG_BOS

    1 Message

    314

    0

    Posted December 7th, 2004 15:00

    I have a new D600 and I have been having a similar issue and every time, very frustrating to get it started sometimes.  Also when I open the DVD/CD drive while its docked the external monitor blanks out and the laptop goes into un-docked mode and when I try to re-connect the network adapter won't work.  I always have to shut down and delete the hardware profile and then restart again before it is recognized.  Otherwise the DVD/CD drive and laptop work fine outside of the docking station.
  • menlo

    3 Posts

    314

    0

    Posted December 7th, 2004 16:00

    So it seems that the connection between the port replicator and monitor stand is the problem we're having.  The users are able to power on by reaching under and pressing the power button that is on the port replicator.  The monitor stand button worked breifly after reseating the port replicator.