UNSOLVED

Erict47

updated

21 years ago

Closed

E

Erict47

11 Posts

0

5158

October 25th, 2005 18:00

Inspiron 8200 motherboard part number confusion

My inspiron 8200 needs a new mother board and none at dell spare parts told part number is 9P053. I removed my board and the numbers on the board by the ram are DS/NCN-06G040-1291-24f-86641. Several boards are on e-bay listed as inspiron or latitude 06G040 which matches part of mine. Are all inspiron 8200's use the same boards are they interchangeable with latitudes? Most of the boards would require me to switch over heatsink and CPU, modem etc. from my board. Any help regarding compatability and issues regarding installation would be helpful. I want to get the correct board, it is difficult to find out about these different numbers as I read in the forum I may need to flash to the correct bios (latitude or inspiron) any other issues?   Any help greatly appreciated!
  • AussieChris

    4152 Posts

    193

    0

    Posted October 25th, 2005 21:00

    Hi,

    Your board is a 6G040. It will fit either model. There are some other number that will also work. It will take an M50 board as well. You have to force the Bios to flash over. Everything else should be OK.

                                                                                        Regards Chris

  • AussieChris

    4152 Posts

    193

    0

    Posted October 25th, 2005 22:00

    Hi,

    If you have to flash the Bios over, you will have to force it. Boot into DOS, get the exe file and I8200_a11 /jabil should flash it over. Do a dir to see the file. Some use a . and others a _ You dont need the .exe The space /jabil will force it.

                                                                         Regards Chris

  • Erict47

    11 Posts

    193

    0

    Posted October 25th, 2005 22:00

    Thanks Chris for the help I will purchase the board on e-bay hope all goes well a
    nd will down load Bios A11 from dell site to update bios of board if it is a latitude bios.
    Thank You!
    Eric
  • Erict47

    11 Posts

    193

    0

    Posted October 26th, 2005 00:00

    Chris

    Thanks for all the help and will take your advice on re-flashing if needed and will save me time finding out how to force the Bios over to inspiron if needed, I will use a floppy drive method more safe, I hope. Youve been very helpful thank you!

    Thanks Again!

    Eric