UNSOLVED

Lexmike

updated

21 years ago

Closed

L

Lexmike

13 Posts

0

2217

June 16th, 2005 17:00

8600 Infrared

You'd think by now I'd quit buying these things without software (though once all installed they are great!) but I can not for the life of me find an installable infrared driver for XP.Can someone point me in the right direction?
  • ejn63

    11 Legend

    •

    87469 Posts

    •

    321256 Points

    367

    0

    Posted June 16th, 2005 19:00

    XP has full IR support. Make sure the IR is enabled in system setup (it's disabled by default). Once you enable it, Windows will detect and install a driver for you.
  • Bay Wolf

    4438 Posts

    367

    0

    Posted June 17th, 2005 03:00

    Which I8600 to you have?  The one with or without the serial and parallel connections on the back?  The reason that I ask is that the I8600c (of which I have) does not come with the IR.  Only the original did.
     
    The original I8600 is the one that has the serial and parallel connections on the back.
     
    I just wanted to make sure that yours had it.
     
     
     
  • Bay Wolf

    4438 Posts

    367

    0

    Posted June 17th, 2005 03:00

    I looked up the instructions for enabling the IR on the I8600:

    Enabling the Infrared Sensor

    1. Enter the system setup program:
           a Turn on your computer.
           b Press F2 when the DELL™ logo appears.
    2. Press Alt P until you locate Infrared Data Port under Basic Device Configuration.
    3. Press the down-arrow key to select the Infrared Data Port setting, and press the rightarrow key to change the setting to a COM port.
    4. Press the down-arrow key to select the Infrared Mode setting, and press the rightarrow key to change the setting to Fast IR or Slow IR.
      1. It is recommended that you use Fast IR. If the infrared device cannot communicate with your computer, shut down the computer and repeat steps 1 through 5 to change the setting to Slow IR.
    5. Press ESC and then click Yes to save the changes and exit the system setup program.
      If you are prompted to restart your computer, click Yes.
    6. Follow the instructions on the screen.
    7. After the infrared sensor has been enabled, click Yes to restart the computer.
      After you enable the infrared sensor, you can use it to establish a link to an infrared device.
      To set up and use an infrared device, see the infrared device documentation and the Microsoft® Windows® Help and Support Center.

     

  • Lexmike

    13 Posts

    367

    0

    Posted June 17th, 2005 13:00

    I apparently have the original. It has both parallel and serial ports.