
UNSOLVED
How to use Dell Diagnostics in Diskette Drive to test CD ROM?
My CDROM went bad (I think) and I want to run dell diagnostics to test. I downloaded the file from dell support and have them on 5 diskette drives. When I load the first and boot, it loads a few devices and does not proceed to other diskette. When I browse the other diskettes they are files for other devices. I cannot copy delldiag.exe on all diskettes as there is not enough space. What should I do if I have to run all tests?
Appreciate your assistance.
Responses (5)
Solutions (0)
That sint going to work Stalker is CDROM drive is fried.
First, what model dimension do you have?
If later than 4300, try hitting F12 at the Dell screen. You should then get a boot device menu. Choose utility partition. Now choose Run 32 bit diags from the on screen prompt. But this only works for POST 4300 systems. Hope this helps.
shanesspldrtn1
81 Posts
543
0
Posted November 8th, 2002 11:00
Bramesh,
Try this. Enter the BIOS and set your CDROM as the first boot device. Try booting to your Resource CD or other bootable media. If you can boot to the disks, then your cdrom is fine and it is probably windows giving you a hard time. If you can't boot to the RCD, then turn off the system, open the chassis and reseat all the cabling to the drive and give it another try. If you still can't boot the cdrom then you should call Dell and have the drive replaced as it is probably bad.
- The disk you created are corrupt. You need to use another set of disk to create the diagnostics, if this fails you need to download the file and start over. After you load the first disk, you should be asked for the second, then third etc. After all the disk are loaded, you should get the diagnostic menu. You need to have a readable disk in the drive to run the diagnostics or the drive will fail.

NetStalker
9 Posts
543
0
Posted November 8th, 2002 08:00
<ADMIN NOTE: Broken link has been removed from this post by Dell>