UNSOLVED

MrHobby

updated

21 years ago

M

MrHobby

2 Posts

0

2309

February 9th, 2006 01:00

can't get moniter to reconize graphics card?

hi.  i'm sorry about this post, i'm sure it was covered somewhere, but i couldn't find it in my searches.
Problem,
When i installed a graphics card on an intergrated graphics motherboard, the moniter automatically goes into "sleep", standby mode when the pc in turned on. I've have tried several cards, (all types and sizes), with the same results. I curently am building a powerhouse pc to run MAYA, (a topshelf CG program), useing the same dell monitor that was with my other pc, and am getting the same results. I have come to the conclusion that it might be the moniter. If anyone can give me advise or point me in the right direction, it would be greatly appreciated.:manvery-happy:
 
Hardware.
Moniter = 17 inch dell crt -E773c
Card = ATI Radeon X300LE  256mb
Motherboard = Lanparty UT nF4 Ultra-D running a 3.2ghz AMD Athlon 64
 
Thanks in advance for any help.
  • shaxl

    104 Posts

    172

    0

    Posted February 9th, 2006 11:00

    you installeed all the necessary drivers for the video card?

    plus consumer cards stinkk for CG apps. spend the extra money and go for a FireGL or Quadro based card. the performance increase in those apps is extemely large with a workstation card. but then again workstation cards stink for gaming so...

    Message Edited by shaxl on 02-09-2006 08:04 AM

  • 172

    0

    Posted February 10th, 2006 15:00

    -run the monitor self-test by unplugging the signal cable from the system while the monitor's power cord is still plugged in. if the monitor would show a colored moving box across the screen while the signal cable is unplugged,themonitor is good.

    -try to run the auto-adjust button on your flat panel(usually, beside the plus button)

    -be sure that you have disabled the integrated video card within the system setup before installing a video card.

    -try a known good signal cable.

    -make sure that the video crad is properly seated on the AGP slot

     

    hope these could help

  • MrHobby

    2 Posts

    172

    0

    Posted February 10th, 2006 20:00

    Thanks for the replies.

    My graphics card is a pci express. The problem is i'm building a high-perfomance pc from scratch, and using a 17 inch dell crt moniter that belonged to my old dell dimension 3000.  The motherboard, graphics card, harddrive, and sound card are all brand new, and i cant view the system through the moniter to install the proper drivers for eveything. (the motherboard has no built-in intergrated graphics.) I'm wondering if i have to hook-up my new harddrive to the old pc and install drivers for everything, then install it into my new pc? would you happen to know if this would work? I could also install the new graphics card on the old pc with the new harddrive and try to install those drivers as well.

    (ya, i'm trying to build from scratch and i'm in over my head.  lol)

    thank you for your replies posted already. :smileyhappy:

    Message Edited by MrHobby on 02-10-2006 04:12 PM