UNSOLVED

TrevNethers

updated

1 year ago

T

TrevNethers

1 Rookie

•

2 Posts

•

2 Points

0

911

May 21st, 2024 20:37

Inspiron 3880 PSU 300w Upgrade

My desktop is an Inspiron 3880. I need to upgrade my GPU to an ASUS GTX 1050ti, which requires a 300w PSU. The included PSU is 200w. I purchased a 300w PSU from Dell on referral from a Dell representative. However, this 300w PSU has different connectors.

Two questions:
Is there any way to use this 300w PSU with my desktop via adapters?
Can I use this ASUS GPU without upgrading the PSU?

Thanks in advance for help!

  • RoHe

    12 Elder

    •

    45230 Posts

    •

    172625 Points

    0

    0

    Posted May 22nd, 2024 01:13

    Read these threads, here and here. 

    PC may not boot with the existing PSU if it can't handle the load from the new GPU, and that extra load could cause damage.

    And keep in mind that you may have to disable Secure Boot in BIOS setup, before installing any after-market GPU or PC may not boot. So make this change after you get the new PSU connected and everything is working properly with the existing GPU.  Then swap in the new GPU...

  • redxps630

    11 Legend

    •

    16431 Posts

    •

    83176 Points

    0

    0

    Posted May 22nd, 2024 17:15

    You cannot use the 300w psu. It is meant for Inspiron 3910 and newer models which use 8 pin Dell proprietary connector on motherboard.  3880 uses older 6 pin connector.  The 8 pin and 6 pin out are completely different and incompatible.

    You could purchase a Dell oem 360w psu that has 6+4 pin c/w 3880.  there are also 260w oem psu compatible too.

    you could try test the 200w for the 1050ti but gpu may be underpowered.  No harm is done doing the test. Worst case scenario pc would shut down.
    psu calculator shows load wattage is 211w using nvme ssd only w 1050ti in 3880. so 200w is just a bit low.
  • DIMENSION 5150

    1 Rookie

    •

    8 Posts

    0

    0

    Posted September 7th, 2024 02:20

    I recently came upon the same problem when helping to upgrade a relatives Dell Inspiron 3880, when I went to the power supply upgrade list the options were slim pickings a 200 watt and a 260 watt. So I clicked on the 200 watt power supply and went to compatibility list and after scrolling through the list and searching psu upgrades , I came across a 360 watt power supply for a OptiPlex 7060 Tower which happened to be compatible with the 200 watt power supply from the Inspiron 3880, Both machines use a 6 pin atx + 4 pin atx and the 360 watt comes with a bonus 6 pin gpu power connector.

  • DIMENSION 5150

    1 Rookie

    •

    8 Posts

    0

    0

    Posted September 8th, 2024 13:48

    Dell part R4T90 : Dell - 200W Power Supply

    Compatibility

    This product is compatible with the following systems:

        Inspiron 3268 SFF
        Inspiron 3470 SFF
        Inspiron 3471 SFF
        Inspiron 3472
        Inspiron 3880 Desktop
        OptiPlex 3060 Small Form Factor
        OptiPlex 3060 Tower
        OptiPlex 3070 Small Form Factor
        OptiPlex 3070 Tower
        OptiPlex 3080 Small Form Factor
        OptiPlex 3080 Tower
        OptiPlex 5060 Small Form Factor
        OptiPlex 5060 Tower
        OptiPlex 5070 Small Form Factor
        OptiPlex 5070 Tower
        OptiPlex 7060 Micro
        Optiplex 7060 Small Form Factor
        OptiPlex 7060 Tower
        OptiPlex 7070 Small Form Factor
        OptiPlex 7070 Tower
        Precision Workstation 3430 SFF
        Precision Workstation 3430 XL
        Precision Workstation 3431 SFF
        Vostro 3470 SFF
        Vostro 3471 SFF
        Vostro 3681 Small Form Factor
        Vostro 3888 Tower

  • bradthetechnut

    9 Technologist

    •

    9712 Posts

    •

    40924 Points

    0

    0

    Posted September 9th, 2024 02:54

    @DIMENSION 5150 ​ 

    No need to duplicate post.  OP is looking for 300w PSU.

    A list of PSU compatibilities is a good start for your own thread. 

  • user_065e26

    1 Rookie

    •

    4 Posts

    •

    2 Points

    0

    0

    Posted August 18th, 2025 15:12

    How did you get this PSU?

  • TrevNethers

    1 Rookie

    •

    2 Posts

    •

    2 Points

    0

    0

    Posted August 18th, 2025 17:34

    @user_065e26​ I ordered it directly from Dell through their customer service number. Actually, I returned it because it was incompatible with my system and I just used my original PSU with the new graphics card. I've been building Unreal Engine 5 prototypes without issue.

  • Wraiththe

    1 Rookie

    •

    2 Posts

    •

    2 Points

    0

    0

    Posted November 5th, 2025 18:17

    @DIMENSION 5150 ​ 

    No one ever mentioned the model number or if it worked.

    I found this one on amazon: 

    H360EGM-00 360W Power Supply Compatible with Dell Optiplex 
    3050 7050 7060 3050MT 7050MT 7060MT Vostro 3668 3669,
    D360E001L L360EGM-00 8HKG7
    at H T T P S  :  //www.amazon.com/Lrker-Compatible-H360EGM-00-D360E001L-L360EGM-00/dp/B0D2QYJVQ8

    this is the one?

  • Mobius One

    1 Rookie

    •

    51 Posts

    0

    0

    Posted December 6th, 2025 06:37

    Just plug the thing in anyways as the pins are the same if it is one of the older 8pins.

    Why are the Dell forums so full of know-it-alls that know nothing about any of the hardware but always have some definitive answer for nothing they have ever thought of attempting?

    Dell PSUs have some good capacitors so that 300W recommendation is for cheap Power Supplies that produce power spikes.  A 260W DELL PSU WILL HANDLE A 1060 6GB even with no issues!

    i stuck a wide PSU (460w) out of an XE3 or something into a 6pin connector motherboard and the voltage pins matched where they needed to go.

    Also, a 260W PSU from Dell is enough juice to power a 1660ti or Super (120W) GPU with SATA to 8pin.  There will be some browning on the +12V connector plastic, but 400 hours worth of use hasn’t melted anything.

    and since went ahead and bought a 300W for no reason since Dell says these 1050tis work fine since the slot provides the 75 watts necessary, get yourself an RTX 2060 and some Y adaptors to link to that extra 6pin wire you have.  You will need 2 free SATA ports since one might not keep up with a 150W GPU if you have an i7 taxing the wattage too.  


    Heck, a 3060 12GB might work, but ai’ll try a 3060ti for the heck of it in my nephew’s computer with all the latter since it’s that much better of a card than the 12GB!