UNSOLVED

iMoses

updated

7 years ago

I

iMoses

2 Posts

2

4075

November 18th, 2019 09:00

Dual Monitors using XPS 13 7390 and WD19 with Ubuntu 19.10

I've received from my work place a new XPS 13 7390 which comes with Windows 10 pre-installed but I require Ubuntu to do my job properly. After some issues with the boot I've managed to install Ubuntu 19.10 but I'm experiencing an issue with my monitors when they're connected to the docking station (WD19) using DisplayPort (or HDMI, which I also tried). Both the monitors are also Dell's (P2418D) if it matters.

Problem is that while connected to the docking station my OS recognizes both displays as only a single display and automatically mirrors between them, so that according to Ubuntu I have the built-in display and only a single additional display and I can't seem to get past it. When I tried the same using Windows 10 it works as expected and if I disconnect one of the monitors from the docking station and reconnect it to the second USB-C input on my laptop it also works as expected. The issue only seem to happen when both monitors are connected to the docking station which the laptop connects to using USB-C.

Is there any way that I can make it work without blocking my additional input, using the docking station alone?

  • aj.johnson

    1 Rookie

    •

    3 Posts

    3552

    0

    Posted January 3rd, 2020 14:00

    Did you get this working? I have a 7390 with a WD19TB dock and am having similar issues.

  • jphughan

    11 Legend

    •

    13985 Posts

    •

    79931 Points

    3545

    0

    Posted January 3rd, 2020 17:00

    I'm wondering if Ubuntu doesn't support DisplayPort MST?  That's essentially a technology that allows multiple displays to be driven from a single DisplayPort output coming from the GPU as long as the bandwidth requirements of all displays fit within the bandwidth of that link.  If that isn't supported, then only one display's signal can be sent on a DisplayPort link, which would lead to mirroring of there are multiple physical displays on the other end of that link -- and since the WD19 only taps into the single DisplayPort interface available over USB-C, that might explain the issue.  Still, given how long DisplayPort MST has existed, I would expect that a recent Ubuntu kernel would support this, or if it didn't that this type of limitation would be noted in the WD19's manual on support.dell.com.

    I'm also not sure that this would explain this behavior on the WD19TB, which can tap into two DisplayPort interfaces from the GPU since it uses Thunderbolt rather than USB-C.  In that case, as long as you're only running two displays on the WD19TB, each display would get its own link, and on Linux two displays is all you can run because the Intel GPU only supports 3 displays total, and on Linux (unlike Windows) the built-in display can't be completely disabled, so that display always counts as one.  And again, I would expect a limitation like this to be called out in the WD19TB's documentation, and on a quick reading I don't see anything like that.

  • h.med

    2 Posts

    3435

    0

    Posted January 12th, 2020 12:00

    Hello,

    I am facing the same problem and what is strange is that the problem is only with the left USB Type-c port where perfectly working with the right USB typeC port.

    Please any updates or tips/solutions?

  • h.med

    2 Posts

    3431

    0

    Posted January 12th, 2020 12:00

    I am facing the same problem with same configuration and to give more details, i am getting the problem with only the right port:
           Windows 10 = OK
           Ubuntu 19.10 - Right Port = OK
           Ubuntu 19.10 Left Port = NOK