
UNSOLVED
Dell XPS 13 9350: Elan Touchpad (VEN_04F3) freezes after s2idle sleep following System Firmware 1.25.0 update
Disclaimer. This is an AI summary of a bug I encountered today after the firmware update from yesterday. I'm a real human being, though. I swear. All fireware and software is as new as it can be.
Dell Inc. XPS 13 9350
Ubuntu 26.04.1 LTS
Intel® Core™ Ultra 7 256V × 8
Linux 7.0.0-38-generic
After updating the System Firmware on the Dell XPS 13 9350 (2024 / Intel Core Ultra) from v1.22.0 to v1.25.0, the Elan Touchpad (i2c-VEN_04F3:00) ceases to function properly after resuming from prolonged s2idle sleep (suspend-to-idle).
While the cursor movement via HID sometimes remains active, multi-touch gestures and click events fail to register completely.
Expected Behavior:
The touchpad should fully resume and respond to clicks and gestures immediately after waking up from s2idle.
Actual Behavior:
Following s2idle sleep exceeding ~15–30 minutes, the touchpad IRQ/event handler fails to re-initialize. A session logout or reloading the I2C modules (modprobe -r i2c_hid_acpi i2c_hid && modprobe i2c_hid_acpi) temporarily restores functionality until the next sleep cycle.
Root Cause Analysis:
The issue appears to be an ACPI / Runtime Power Management regression introduced in System Firmware 1.25.0. The new UEFI update forces the Intel DesignWare I2C controller (0000:00:15.2) and the Elan touchpad into an aggressive low-power state during s2idle from which the Linux kernel fails to wake the device.
System Environment:
Laptop Model: Dell XPS 13 9350 (2024)
OS: Ubuntu 26.04 LTS (Kernel: 6.x)
Touchpad Hardware: Elan Microelectronics (
i2c-VEN_04F3:00viai2c_designware.1)Firmware Version: System Firmware
1.25.0(Updated viafwupd/ LVFS)Suspend Mode:
s2idle(/sys/power/mem_sleep)
Workaround / Fix Verification:
Disabling Runtime PM (Autosuspend) for the I2C device and parent PCI bridge completely resolves the issue without needing module resets:
Bash
echo "on" | sudo tee /sys/bus/i2c/devices/i2c-VEN_04F3:00/power/controlecho "on" | sudo tee /sys/bus/pci/devices/0000:00:15.2/power/control
Setting power/control to on keeps the I2C bus responsive after wake-up, confirming that aggressive firmware-level Power-Gating in 1.25.0 is preventing proper IRQ resume.
Responses (0)
Solutions (0)
