UNSOLVED

JRanalli

updated

12 years ago

J

JRanalli

5 Posts

0

1940

September 11th, 2014 10:00

I am testing the conversion of an FA to a RF (RA) director, and receiving an error that the director has port in use.

FA director 9G, both ports 0 and 1 have no mapped devices, and have been disabled.  So the director itself also shows that it is offline.

But, when trying to convert that FA to a RF (RA) port, it fails using Unisphere, and we get the same error using symconfigure on the command line:

The command line error is:

Execute a symconfigure operation for symmetrix '000192606585' (y/ ) ? y

A Configuration Change operation is in progress. Please wait...

    Establishing a configuration change session...............Established.

    Error occurred while Defining change number 1:
    The operation can not be performed because the director has port in use
    Terminating the configuration change session..............Done.

The configuration change session has failed.

What is the possible problem ?

  • 1040

    0

    Posted September 26th, 2014 07:00

    Please check the below conditions.

    1. The Ports on the FA-9G should not be part of any port groups.
    2. All the ports on the FA-9G must be offline.
  • mat_wood

    1 Message

    1040

    0

    Posted February 9th, 2015 15:00

    For a FA to be converted to RF. You need to have the following things in place.

    1. Enginuity 5876.

    2. Conversion of directors must be done bottom up starting from H director, For a G director to be converted to RF then H director must be either RF or GIGE .

    I hope this helps.

  • Ugin

    1 Rookie

    •

    122 Posts

    1040

    0

    Posted February 9th, 2015 22:00

    All IO's should be stopped, once you confirmed that the IO's stopped then the FA port can taken to offline.

    If unable to do, then support or the local EMC team can help you to bring the port offline.