UNSOLVED

parathyroidhorm

updated

11 years ago

0

1006

March 8th, 2016 01:00

How to view the IO in a metro srdf?

Hi,

If the customer is using metro SRDF, how to check where is the host access all the reads and writes (from which array)? Customer will like know as this will be helpful to troubleshoot the array when there is an issue with the array.

Please kindly advise.

Thank you.

  • 339

    2

    Posted March 8th, 2016 06:00

    Hi Darren,

    Are you asking if there is a way to tell which VMAX3 is servicing any given read or write on a host connected to both sides of a metro RDF group? If we are in ACTIVE-ACTIVE mode with High-Availability all paths available to the host are serviced as evenly as possible ( Multipathing software i.e. PP, DMP, native etc. ). Since SRDF/S is the underlying replication architecture the level to which a particular path is available depends on the underlying SAN  infrastructure.

    So as an extreme example if one V3 is connected directly to a host and the other V3 is connected via a large SAN then the direct connected host path will be utilized more as the AWKs will take longer to traverse the SAN.

    In short other than monitoring paths for a single I/O we leave the Multipathing software determine the box to service any I/O in a single host scenario.

    ps.... even with a multitrack I/O a write can be split down both paths to different Boxes.

    R

  • 339

    0

    Posted March 8th, 2016 10:00

    Hi R,

    If for example, the environment is having SRDF/Metro on V3a and V3b, but on the host end, multipathing is set as preferred IO on V3a.

    Is there a way to determine IO information via Unisphere or symcli rather than the multipath software?

    Thank you.

  • 339

    1

    Posted March 9th, 2016 00:00

    Hi,

    If you are directing traffic down an known path that you can easily monitor activity via Unisphere Performance Viewer.

    This can be achieved using a wide variety of options from SG centric to Port centric down to the granularity of individual Symm devices. It's a comprehensive tool I would suggest you play with you get a full underfstanding of its capabilities.

    From a CLI perspective I would explore the symstat suite of commands.

    R