About the external locks... this is from the CLI product guide
Symmetrix external locks Symmetrix external locks are used by SYMAPI (locks 0 to 15) and also for applications assigned by EMC (>15) to lock access to the entire Symmetrix array during critical operations. (Base SRDF operations use lock 0 and the Optimizer uses lock 13.) Using the symcfg list -lockn parameters, you can list all locks on one or all arrays or just those locks targeted to specific operations.A list can be returned for all, a specific number, only RDF, only RDF-A, only MSCS, or only GNS locks (ALL, #, RDF, RDFA, SRDF_MSCS, and GNS values respectively). All possible locks To return a list of all host-visible Symmetrix arrays (local and remote), along with details about all Symmetrix exclusive locks (known to SYMAPI) that are currently locked,
enter:symcfg list -lockn all
Details about a specific lock number To focus your returned data on one or all lock number(s) on one or all Symmetrix array(s), use the -lockn option. For example, to return a list of all host-visible Symmetrix arrays (local and remote), along with details about any lock 0,
The command to view the Lock Holder ID is: symcfg list -lockn 15 -v If the Config Lock is set, then you need to decode the first 4 digits of the Lock Holder ID to determine the source of the lock.
Lock Holder ID is E002: it was set by EMC personnel from the SymmWin Procedure to prevent any config change. This normally gets set in preparation for a CCA activity
Lock Holder ID is E001: it was set by an Online Config Change or Online Code Load. Please contact the EMC Support Center for assistance.
Lock Holder ID is E301: it was set by SymmWin for either symconfigure or EMC ControlCenter Configuration Manager Session from a host. Check to make sure where these operations are occurring to determine if the lock can be released
For further lock display/release options and information, refer to solution emc91997
Vivekjaiswal001
49 Posts
375
0
Posted September 30th, 2009 04:00
Fristly welcome to th forums!!!!
About the external locks... this is from the CLI product guide
Symmetrix external locks
Symmetrix external locks are used by SYMAPI (locks 0 to 15) and also for
applications assigned by EMC (>15) to lock access to the entire Symmetrix array
during critical operations. (Base SRDF operations use lock 0 and the Optimizer uses lock 13.) Using the symcfg list -lockn parameters, you can list all locks on one or all arrays or just those locks targeted to specific operations.A list can be returned for all, a specific number, only RDF, only RDF-A, only MSCS, or only GNS locks (ALL, #, RDF, RDFA, SRDF_MSCS, and GNS values respectively).
All possible locks To return a list of all host-visible Symmetrix arrays (local and remote), along with details about all Symmetrix exclusive locks (known to SYMAPI) that are currently locked,
enter:symcfg list -lockn all
Details about a specific lock number
To focus your returned data on one or all lock number(s) on one or all Symmetrix
array(s), use the -lockn option. For example, to return a list of all host-visible
Symmetrix arrays (local and remote), along with details about any lock 0,
enter:
symcfg list -lockn 0
Also have a look at the primus emc60458
Hope this helps
Regards,
Vivek