UNSOLVED

UCG Musician

updated

18 years ago

0

2704

April 20th, 2009 13:00

RAID 1

My system is a little over 3 years old (and therefore not under warranty, which means Dell has no interest in helping resolve my issue except at my personal expense) and I just had a hard drive failure.

This is one of two hard drives in a RAID 1 setup that I successfully installed.  I bought both hard drives from Dell and installed RAID 1 BECAUSE the HD shipped in the system failed & I didn't want to lose everything again.

I purchased two new hard drives and will set them up with RAID again.  However, I want to do it in exactly the right manner so as to avoid formatting the existing (functioning) HD while the second one is rebuilding the volume.

Please offer advice & tips on how to do this.  The new hard drives have been shipped but not yet delivered.

  • Runninkind1

    11 Posts

    291

    0

    Posted April 20th, 2009 14:00

    Hi Raid 1
  • Runninkind1

    11 Posts

    291

    0

    Posted April 20th, 2009 14:00

    You may not have warrenty service any more with Dell but you can still look up your service tag and configurations on the support page. Depending on your system, be sure to download all drivers if you do not have your original drivers disks for your system. The important thing you will need is the Intel matrix storage and once more depending on your system and how it was setup. But this utility for example is used to do your raid configurations.

    Runninkind1

  • shesagordie

    12 Elder

    •

    46017 Posts

    291

    0

    Posted April 20th, 2009 21:00

    My system is a little over 3 years old (and therefore not under warranty, which means Dell has no interest in helping resolve my issue except at my personal expense) and I just had a hard drive failure.

    This is one of two hard drives in a RAID 1 setup that I successfully installed.  I bought both hard drives from Dell and installed RAID 1 BECAUSE the HD shipped in the system failed & I didn't want to lose everything again.

    I purchased two new hard drives and will set them up with RAID again.  However, I want to do it in exactly the right manner so as to avoid formatting the existing (functioning) HD while the second one is rebuilding the volume.

    Please offer advice & tips on how to do this.  The new hard drives have been shipped but not yet delivered.

     

    UCG Musician

    What is the computer model and the version of windows?

    Bev.

  • 291

    0

    Posted April 21st, 2009 18:00

    UCG Musician

    What is the computer model and the version of windows?

    Bev.

    It's a Dimension 5150 (E510) running Windows XP Media Center Edition.

    I want to rebuild the volume on a new drive in Port 2 first & then subsequently rebuild it on a new drive in Port 0.