UNSOLVED

leesiulung8

updated

21 years ago

0

12210

July 2nd, 2005 14:00

Problem: DVD drive runs really slow

I have a Dimension 3000, Windows XP Professional, upgraded with 2 GB Ram... I installed into my computer a Pioneer DVD-RW DVR 105, which should read DVD-R @ 6x, and write DVD-R @ 4x-- but instead read and write no faster than 1x. This Pioneer, on another computer I have, ran normally. Ok, I wasn't sure why I had that problem with the Pioneer DVR-105 on this Dell, and I wanted to upgrade to a faster DVD burner anyway, so I replaced it with a 16x Pioneer DVR-109 Dual Layer Burner, and it also just read and write at only 1x and no faster. I went to the Pioneer website and installed the latest drivers for it, and still, not resolved. Can someone help me fix this problem I have...I have no clue.
  • crossman1

    19 Posts

    576

    0

    Posted July 2nd, 2005 14:00

    You don't by chance have the transfer mode set to PIO instead of DMA do you?
  • 576

    0

    Posted July 2nd, 2005 16:00

    And btw, I have the Pioneer as a 'slave' and the CD drive that came with the Dell the 'master'-- does that matter on the speed??
  • 576

    0

    Posted July 2nd, 2005 16:00

    crossman1,

    First off, thanks for responding...
    but what is that(PIO/DMA) and where do I go set this configuration? I'm sorry, think of me as a newborn with computers.

    leesiulung8
  • Skybird

    1 Rookie

    •

    10871 Posts

    576

    0

    Posted July 2nd, 2005 17:00

    Select Transfer Mode: DMA if Available.  If that does not help,
    consider switching the two drive positions on the IDE cable so
    as to make the DVD burner the Master (end of cable) and the
    other drive the Slave middle of cable).  Both drives should be
    jumpered as Cable Select.
     
     
     
     
     
     
     
     
     
     

    Message Edited by Skybird on 07-02-2005 12:30 PM

  • 576

    0

    Posted July 2nd, 2005 17:00

    I found this online:

    "Enabling/Disabling PIO/DMA

    Open Device Manager: Start - Run - DevMgmt.msc

    Expand the category "IDE ATA/ATAPI Controllers"

    Right click the desired IDE controller (Primary/Secondary) and choose Properties.

    Choose the "Advanced Settings" tab.

    Change "Transfer Mode" as necessary."


    What the IDE Channel Properties gave me is:
    "Transfer Mode: DMA if available"
    "Current Transfer Mode: PIO Mode"

    It appears the it doesn't work in DMA mode...any other advices?
  • crossman1

    19 Posts

    576

    0

    Posted July 2nd, 2005 19:00

    Be sure both drives are jumpered CS, Cable select.  The other thing to do is to enter system setup (F2 at the Dell screen on start up) and check the drive configuration menu to see if both the devices on the secondary IDE are set to auto in the drive type.

    Message Edited by crossman1 on 07-02-2005 03:38 PM

  • 576

    0

    Posted July 2nd, 2005 23:00

    Skybird/crossman1,
    Hey, it's resolved!! Thanks, to the both of you for your tremendous help to me-- I really appreciate it!! Thanks, again!