I have a computer with a 160 Gig Seagate 7200.7 ATA hard drive. It was set as cable select and was the only drive in this computer using Windows 2000.
This computer stopped working. I tested its drive as is in an Windows XP computer as a second drive and all the files were OK. I then attached it to my Dell Dimension 3000 running Windows XP as a second drive first with cable select and then with no jumper as a slave and the computer doesn't see it either way.
The computer it worked in was a generic collection of parts running XP. Why would I have a problem with the Dell Dimension 3000?
But when I did set to auto the Dell came back that the new hard drive was unknown and when it rebooted then said that the primary drive could not be found.
Gave me two options, F1 ignore or F2 go back into setup. Tried to go back into setup but could find nothing else to do there so tried F1 and it then rebooted fine but again no sign of the other hard drive.
But when I did set to auto the Dell came back that the new hard drive was unknown and when it rebooted then said that the primary drive could not be found.
Gave me two options, F1 ignore or F2 go back into setup. Tried to go back into setup but could find nothing else to do there so tried F1 and it then rebooted fine but again no sign of the other hard drive.
Some possibilities:
1) When you put it back in the 3000, you still didn't have the jumpers on cable select.
2) You hooked it up to the secondary IDE channel (CD/DVD), but turned on the primary channel.
I just had the same trouble
when i set the bios to read AUTO with each drive as cable select I would get the same error as you.....I changed the bios to OFF for the 2nd drive with both cable select jumpers and it WORK!!!! I have no idea why But been using it for over 4 weeks this way and all works normal.
lambdapro
381 Posts
291
0
Posted February 21st, 2006 03:00