My 8400 has an 80GB SATA hard drive.....I want to add a second hard drive (Maxtor 300GB SATA) for video/picture files, etc. with applications on primary drive. I am trying very hard to do this....entered setup on bootup.....tried to activate various SATA connections on motherboard......do not want RAID setup.....getting a lot of blue screens!!!!! need to know how to add a second SATA hard drive in a non-RAID fashion!
I initially mounted the new hd, connected the power and sata connectors, and booted up.....the second drive was not recognized....then I realized that the SATA2 was still 'off' in system setup......when I turned it 'on', the boot drive (SATA0) was not recognized, and windows would no longer bootup.
I think I've finally figured things out.....when I initially installed the second hd, I shut down, opened the computer, attached cables, closed, started up and expected windows to detect the hd.....however the SATA2 (and 1 and 3) connector(s) was not activated......I then did so with the hd still connected...I think that is the problem......I disconnected all hd's, reconnected 'master' hd, rebooted without a problem....THEN, through setup (F2 during boot), turned 'on' SATA2, then shut down and proceeded as I initially did.....drive still not recognized initially....had to (also through setup), change boot up order to put CD drive ahead of SATA so that Maxtor CD would boot up and recognize hd and set it up appropriately......everything is working fine now.....SO FAR!....hope this helps you, davepass!
Here is my Hard Drive (HD) configuration:
Maxtor 7Y250M0 [Hard drive] (250.00 GB) -- drive 1 WDC WD2500JD-75HBB0 [Hard drive] (250.00 GB) -- drive 0. These are both SATA HDs.
My system drive is the WDC, and I added the Maxtor. I did need to enable drive #1 in the BIOS in addition to drive #0 (the system drive). Initially, my computer, although it did see both, it still crashed a lot. I had no jumper at all on the Maxtor, so I figured there must be some trick with the jumpers. I added a jumper to the Maxtor according to the picture I found on Maxtor's website for a "Slave", although I read that the Master/Slave relationship is irrelevant for SATA drives. It looks like adding the jumper did the trick. Now I see both drives, and my computer is quite stable ---no crash that I can trace to the addition of that second HD.
I would still like to get some feedback as to the correct jumper setting for both of my hard drives.
I haven't checked since I finally got it working a few months ago, but if my memory serves me, I think I was advised to set both jumpers to CS as the Master/Slave configuration does not exist with SATA.
ejn63
11 Legend
•
87469 Posts
•
321256 Points
358
0
Posted November 27th, 2004 20:00