UNSOLVED

aggie04ci

updated

21 years ago

A

aggie04ci

24 Posts

0

1557

October 19th, 2005 15:00

8400- Want a Hard Drive fan to help cool it down. Easy to install these?

I've been concerned lately about case temps and cooling. Since I only have one hard drive currently in my computer, I was wanting to buy one of those hard drive fans I see that apparently mount to the bottom of the HD. Does anyone know if these work and if they are easy to install?

I know nothing about them, but know they come with screws. Do I have to drill into my Hard Drive, or are there already holes in there that these fans simply screw into?? Also, where do they plug in?
  • aggie04ci

    24 Posts

    241

    0

    Posted October 19th, 2005 16:00

    Well I have speedfan installed and it says 42C right now. I've seen it fluctuate between 35C and this 42C mark....haven't really seen it higher. You think thats ok? I'll go to the WD site now and see what they say the safe range is for it. I guess I need to know that in order to knwo what temperature to set speedfan to warn me at lol
  • aggie04ci

    24 Posts

    241

    0

    Posted October 19th, 2005 16:00

    also I wonder how the heck yours is 31C....I can't figure out why my case temps seem to be higher than everyone elses. I have a nvidia 6800 GTO card that heats things up a bit, but only have 1 80gig WD HD in my system....and Dell even put in the optional PCI Express cooling fan in there. I'm not sure I've ever seen my temp at 31C unless I had just turned the computer on, as I've seen it around 29C then before it starts going up.
  • RoHe

    12 Elder

    •

    45230 Posts

    •

    172625 Points

    241

    0

    Posted October 19th, 2005 16:00

    Before investing in a fan, grab free copy of speedfan (www.almico.com) and read your HD temps (assuming it has S.M.A.R.T technology). Speedfan can put a small icon next to the clock for continuous display of HD temp. (Speedfan cannot control fan speeds on Dell desktops.) You can configure speedfan to warn if your drive exceeds whatever temp you set either by beeps (annoying!) or pop-up warning message.

    Also, go to the drive maker's site and see what operating range they specify for your HD. Western Digital says 160GB HD in my 8400 is OK up to 55C. Right now it's holding at 31C and the highest I've seen is 42C. If temp starts creeping up, I just open the front flap on the 8400 and temp will drop by 3-5 degrees in a few minutes.

    Ron
  • aggie04ci

    24 Posts

    241

    0

    Posted October 19th, 2005 16:00

    My HD says its range goes up to 55C too, so I guess I'm fine on the temp side. I opened up the front panel thing and the temp dropped to 39C. Guess I'll keep that open from now on!

    So I guess you don't think I need a fan? Only reason I was even considering one was to avoid HD failure because it was too hot, but doesn't look like the temps I'm getting are high enough to damage it.
  • RoHe

    12 Elder

    •

    45230 Posts

    •

    172625 Points

    241

    0

    Posted October 19th, 2005 18:00

    That's definitely warmer than my HD. But I only have the nvidia 6800 so it may not produce as much heat as the GTO. A lot depends on how much disk access you're doing too. When I run intensive HD activities (full antiviral scans, frequent files saves, etc.) the HD does warm up. Also depends on where your tower is located. If you have it in enclosed cabinet or too close to the wall/desk, it will definitely be warmer.

    If you have recent version of nvidia drivers you can monitor temp of the nvidia GPU core and ambient temp around the video card. My core GPU temp is currently 51C and ambient is 39C. Everest-Home software will also report the temps on the nvidia card.

    Getting a fan (or not) has to be your decision. If you're concerned about HD failures, back up your files to CD/DVD on regular frequent basis.

    Ron