UNSOLVED

ELD

updated

22 years ago

E

ELD

5 Posts

0

8290

July 15th, 2004 17:00

Upgrading PV136T to LTO2 tape drives

Hello,


We are upgrading all six LTO1 tape drives in Powervault 136T to LTO2 drives. 


I have several questions on the media and backup software:


1. If we continue using same LTO1 tapes in the new drives, will they need to be reformatted?  (I know that performace with LTO1 tapes in LTO2 drives is only marginally better).  Will BackupExec 9.0 be able to read data off existing LTO1 tapes with new LTO2 drives?


2. Can we mix LTO1 and LTO2 tape media?


Also, besides the firmware upgrade, is there anything else that's required in order to upgrade?  Any known issues?


Thanks,


El

  • DELL-Bob D

    1 Rookie

    •

    899 Posts

    126

    0

    Posted July 16th, 2004 14:00

    1. You will be able to use the LTO1 media in the LTO2 drives. B/E will not need to do anything special to read and write to your pre-existing media. Using the LTO1 media in the LTO2 drive will give you slower performance than if you use LTO2 media, however using LTO1 media in the LTO2 drive will give you slightly better performance than you saw using LTO1 drives.

    2. As long as you stick with LTO2 drives in your library you will be able to mix and match media.

    3. Check support.dell.com for the latest drivers and f/w and you will be good to go.

     

     

  • ELD

    5 Posts

    126

    0

    Posted July 27th, 2004 13:00

    Thanks for the answers!

    Everything is being recognized, and working, except that drives seem to run close to their native speed even when backing up large highly compressable files.  With LTO1 tape drives, these same files were backed up at maximum (compressed) speed.  We are using BackupExec 9.0.  Hardware compression is enabled for each LTO2 tape drive in their BE properties.  We are using Veritas device that are included with BE.  Library's and RMU's firmware were upgraded to the latest version, LTO2 drives already had latest firmware.

    Here are several questions:

    1. Is there anything besides enabling hardware compression in BE that needs to be done (e.g, a switch on the LTO2 drive itself, a tape drive utility program) to turn the compression on?

    2. If the issue is the driver, is it better to upgrade to the one from Dell, or from Veritas?  Dell's support site lists this one for PVT136T, but its description includes SNC module which we don't have (it's directly attached to a 6600 via 2 channels of a single 39160 card):

    http://support.dell.com/support/downloads/format.aspx?c=us&cs=555&l=en&s=biz&SystemID=PWV_DSK_LTO_136T&os=WNT5&osl=en&deviceid=1203&devlib=37&category=0&releaseid=R69046

    3. Are there any known issues or quirks related to LTO2 drives in PV136T and BE?

    Thanks,

    ELD