UNSOLVED

jeffdeford

updated

18 years ago

J

jeffdeford

13 Posts

0

7700

July 7th, 2008 16:00

MD3000 backup strategies

I was considering a topolgy for a web app infrastructure that would utilize consolidated storage. There would be three (3) physical servers connected directly to a primary MD3000 via SAS 5/e connectors.  This array would use faster SAS drives and each server would be configured to boot from the SAN.  This leaves the 4th SAS port available for a backup solution.  Is is possible to connect another MD3000 directly to the primary storage array for the purpose of direct disk-to-disk backups (either via array-based replication or snapshots)?  I do not wish to use tape for backing up anything!
  • Dev Mgr

    6 Operator

    •

    9308 Posts

    •

    3 Points

    308

    0

    Posted July 7th, 2008 17:00

    The MD3000 doesn't support boot-from-SAN if you check page 17 in the MD3000 support matrix (check here).

    You can't connect one MD3000 to another. Also, a server can only connect to a single MD3000 at a time (see first page in the support matrix).

    For backups you want something that you can easily take off-site (having your backups in the same building where your production data is located defeats the purpose if the building goes up in flames or so). A common example of a solution perfect for that is a tape library.
  • jeffdeford

    13 Posts

    308

    0

    Posted July 7th, 2008 19:00

    OK - got it.  I just have very little faith in tape....

     

    I do have a related question - the 3000i supports booting from iSCSI, correct? 

    It is just that the DAS version of the 3000 does not allow for boot from SAN over the SAS 5/e interfaces, correct? 

  • Dev Mgr

    6 Operator

    •

    9308 Posts

    •

    3 Points

    308

    0

    Posted July 7th, 2008 19:00

    I do believe the MD3000i supports boot-from-iSCSI.

    Do make sure you are fully aware how to set up boot-from-iSCSI, how to troubleshoot boot issues, and how to configure it all. You'd then also want at least 1 co-worker that has the same knowledge level.

    You'd have to use Intel NICs for boot from iSCSI or Broadcoms. The MD3000i support matrix explicitly says it doesn't support iSCSI HBAs.

    It's odd that pretty much the whole corporate world uses tape backups and is willing to depend on using tape backups, but you don't have much faith in it.... I do assume you're talking about using LTO or SDLT, and not Travan or so, as those are in a completely different bracket when doing tape backups.
  • Jingle2

    104 Posts

    308

    0

    Posted July 17th, 2008 15:00

    Also, bear in mind that boot-from-SAN, if the servers don't use local swapfiles, they will compete with the data for bandwidth.  I've rarely seen an application that really calls for boot from SAN.