I just purchased a new PowerEdge SC1420. It came with one SATA hard drive hooked up to SATA_0, and I preceded to install two PATA hard drives and that's where a problem occurs. I have setup the BIOS for the Primary IDE to "On" for Master and Slave. The drives are set for cable select. When I boot up the computer with the two PATA hard drives, the boot-up hangs for a little bit, then proceedes to say that it cannot find either Primary IDE drives. If I disconnect drive 2, the computer will find the drive 1, and if i disconnect drive 1, it will find drive 2, so I know that the hard drives are not bad. I can also hook one up to Primary IDE and one up to Secondary IDE and it will find both drives. I have tried two drives (either 2 HDD or HDD and CD) on the Secondary IDE and it will not recognize either drive. I was just wondering why I cannot have two drives on each IDE channel like normal IDE channels permit. I don't see any documentation from Dell to why this does not work. Is this a BIOS problem that will need to be updated? Let me know if you guys can help me out...thanks in advance.
I ran into the same problem with optical drives. I was going to add a DVD reader and a DVD burner to the CD drive. It would only recognize one of them. I verified that the PATA drives were enabled in the BIOS.
sheltonn
23 Posts
306
0
Posted January 19th, 2005 13:00
I used XP Pro if that makes a difference.