Well. If I understood properly, the version you mentioned in your first post is NetWorker Server version and you are trying to backup a NetApp Client from NetWorker server.
In that case are you using snapshot management or a traditional NDMP Backup configuration? for snapshot NetApp supports Volume level snapshots only.
And there is no Support for Cluster-mode system in Snapshot.
Please refer to the below points for NetApp NSM
•Supports volume-level snapshots only. No support for cluster-mode systems or replication (SnapMirror and SnapVault).
•Supports OnTAP 8.0 or later (7-mode only).
•Supports the NetApp proprietary management API kit. The path must contain "zephyr.dll/netappmgmt.so".
•Does not support a temporary mount point for snapshot browse and recover (NetApp on Linux limitation). Must use an existing NFS mount point.
•*Supports in-place and out-of-place recovery of snapshot files but not directories or save sets (unless the save set is a single file), and only to the same volume as the source.
•Supports directed recovery.
Thanks..
Deb
Please Like my Post if you liked it, Please Mark it as Helpful if it helped you, and mark it as Correct Answer if it resolved your query
I just did a test. I backup /EVI/TEST containing the folder congé. The backup went successfull but i can't see the congé folder using Networker user. So, i can't restore.
When i try to enter the folder /EVI/TEST/Congé in the saveset field .... it tells me::: no ASCII characters ... and i even can't enter it..
Yes ASCII character in Save set is not allowed, but while you are backing up the /EVI/TEST/ directory is it showing anything named “Congé” under the backup directory? If yes then are you able to restore that?
If no then if you login to NetApp filer can you browse the path /EVI/TEST/ Congé or from any other system who is having access there?
Is it possible the path is /EVI/TEST/ Conge and not /EVI/TEST/ Congé
Thanks..
Deb
Please Like my Post if you liked it, Please Mark it as Helpful if it helped you, and mark it as Correct Answer if it resolved your query
A NDMP backup never shows the files it is currently backing up. At the end the savegroup ended with success. A backup using a Networker client does show every file it takes..
So, i can't tell if it took the file. I also don't see /EVI/TEST/Conge....
What vol lang do you use for volume? UTF8? If so, do you use on NW side UTF8=y? Actually, I'm not sure if this is allowed any longer (supported) under never OnTap version so you better check NetApp guide for NDMP backup which identifies supported variables.
ble1
6 Operator
•
14354 Posts
•
56186 Points
1560
1
Posted May 26th, 2015 12:00
8.3 does not exist. NW supports unicode and if I remember correctly, locale on server and client should match (important for restore).