Reconfig storage node after changing Legato servername
Hi,
Recently, I have installed a Legato 7.6.3.2 on Win2K8 connected to a HP Jukebox MSL8096. I have also installed a storage node V 7.6.3.2 and configured the 4 tapes
of the Legato server as rd=.... devices on the storage node. I could make a backup without problems.
I have now renamed my Legato server and re-installed Legato 7.6.3.2 and the Legato storage node. The storage node s-laf-zy1 kept its name.
I now have bizar, erronous behaviour if the re-configuration of the Storage node rd=.... devices.
I get:
Detection process for the host s-olaf-zy1 reports RPC error: 347: Authentication error: Errno: 943
Search for new backup device completed with one failure.
I already re-tried several times to delete the library .... and the storage node .... but i always get the same error...
As mentioned in your note that you have installed networker once and uninstalled it and then again installed the package by renaming the server and storage node.
If I assume correctly you might have installed the package in the same path as it was before.
For example: Install 1: C\program files\legato\nsr
Install 2: C\program files\legato\nsr
Since the path used was same, there is a conflict in the package and names.
I would suggest you to perform the following tasks:
1. uninstall the Networker packages from both server and storage node
2. Rename the folders C\program files\legato in both networker server and storage node
3. Reboot both the server and storage node machines
4. Reboot your library
5. Install the Networker package in the server and the storage nodes with the desired names
6. Make sure the naming convention is done correctly
7. Check the connectivity of your Library from the storage node
8. Run "jbconfig" command to configure your library
Use this article to perform the library configuration
Did you configure the servers file and fail to reconfigure it? When you state you re-installed the Networker software did you uninstall Networker (and delete the nsr directory) or did you just run the installation package again?
pn1lDbv3G612259
105 Posts
574
0
Posted April 24th, 2012 09:00
Hi Johan,
As mentioned in your note that you have installed networker once and uninstalled it and then again installed the package by renaming the server and storage node.
If I assume correctly you might have installed the package in the same path as it was before.
For example: Install 1: C\program files\legato\nsr
Install 2: C\program files\legato\nsr
Since the path used was same, there is a conflict in the package and names.
I would suggest you to perform the following tasks:
1. uninstall the Networker packages from both server and storage node
2. Rename the folders C\program files\legato in both networker server and storage node
3. Reboot both the server and storage node machines
4. Reboot your library
5. Install the Networker package in the server and the storage nodes with the desired names
6. Make sure the naming convention is done correctly
7. Check the connectivity of your Library from the storage node
8. Run "jbconfig" command to configure your library
Use this article to perform the library configuration
http://solutions.emc.com/EMCSolutionView.asp?id=esg117491&usertype=C
Thanks and regards
ShivaKiran