Well ... with Qlogic HBAs, you would need to use sansurfer to the persistant binding and ensure that all the drives are bound to specific targets. Yes, you would need to make sure of the drivers as well.
I have never had a problem where the targets have changed provided the persistant binding is properly applied. Of course, if you change one of the tape drives it self, you would need to do the binding all over again.
Software for persistant binding would depend on wether you are using Qlogic HBAs, Emulex HBAs or SCSI connected devices. Use sansurfer for Qlogic, HBAnywhere for Emulex and you would need to change some registry keys if SCSI connected rather than SAN.
Unless you apply persistant binding both for your library and for the tape drives in it, you will face this problem with both the library and the tape drives.
Make sure your Qlogic drivers are up to date as well as getting the tape device drivers from IBM (make sure you disable the Control port failover with the disableCPF.reg file).
Mine occasionally switch names in Windows e.g. \\.\Tape0 becomes \\.\Tape7 and vice versa. Even though the scsi address appears to stay the same. Its extremely frustrating when you have to delete/readd/reconfigure your jukeboxes.
But at least with 7.4.3 it takes little time to re-inventory compared with older versions.
Hari5
443 Posts
783
0
Posted January 7th, 2009 16:00
I have never had a problem where the targets have changed provided the persistant binding is properly applied. Of course, if you change one of the tape drives it self, you would need to do the binding all over again.
Software for persistant binding would depend on wether you are using Qlogic HBAs, Emulex HBAs or SCSI connected devices. Use sansurfer for Qlogic, HBAnywhere for Emulex and you would need to change some registry keys if SCSI connected rather than SAN.