UNSOLVED

harekrsna

updated

21 years ago

H

harekrsna

25 Posts

0

20001

March 12th, 2006 12:00

Help! Getting crackling audio on Dell Dimension 8250 w/ SB Audigy 2

Every so often I'll get a pop, or crackle from my speakers when I have the subwoofer powered on (it supplies power to the speakers as the speakers are directly connected to the subwoofer). Even if the volume is muted, the speakers will pop from time to time. It has gotten extremely annoying, and I can't even bear to keep the speakers on at all now.

This has happened ever since I had to renovate my room. I took out the system, had to set it up again, but this time, I have an extra connector in between the surround speakers and the subwoofer, as the cable for the surround speakers was too short (they're mounted on the rear wall). Because I had removed carpeting in my room, the only way for the speaker cables to be wired was for them to go along the wall to the wall against which my desktop is, and that's where the subwoofer is. I bought some radioshack extension cables for this task and used them to connect to the rear surround speaker cables, and then connect to the subwoofer. I also had to re-install Windows XP because my OS had been corrupted. Ever since all this, my speakers have been popping like crazy, and it's a very frustrating experience. Any ideas on what may be wrong and what I could do to fix this?
  • fireberd

    11 Legend

    •

    33399 Posts

    •

    112848 Points

    644

    0

    Posted March 12th, 2006 12:00

    I would look at all the connections in the speaker system and make sure all plugs are fully inserted
    as a loose or plug not fully inserted can cause this.  A bad cable can also cause the cracking.  I'd especially look at the extension cable you installed, and make sure it's the correct type and that it is not pinched anywhere or broken and causing problems.  I suspect that if you disconnect the speakers from the PC and then power on the speakers you will still get the noise which further isolates it to the speaker system.
     
    Even if everything is fully plugged in, etc, unplug each connector and then replug it just in case one isn't making good contact.  Also, wiggle the wires at each connector to see if there is a defective plug/cable.
    Inspiron 16 5630 Laptop and WD22TB4 Docking Station
    Self-built desktop for recording studio application
  • harekrsna

    25 Posts

    644

    0

    Posted March 12th, 2006 13:00

    I just tried headphones as well, and I experience crackling in this as well.

    Could this be a driver problem? I had difficulty installing the sound drivers, as I didn't have the original CD with the SB audigy 2 drivers with me. I first used generic sblive drivers, then downloaded the latest sb audigy drivers to update it to sb audigy.
  • harekrsna

    25 Posts

    644

    0

    Posted March 12th, 2006 13:00

    " I would look at all the connections in the speaker system and make sure all plugs are fully inserted as a loose or plug not fully inserted can cause this. A bad cable can also cause the cracking. I'd especially look at the extension cable you installed, and make sure it's the correct type and that it is not pinched anywhere or broken and causing problems. I suspect that if you disconnect the speakers from the PC and then power on the speakers you will still get the noise which further isolates it to the speaker system. Even if everything is fully plugged in, etc, unplug each connector and then replug it just in case one isn't making good contact. Also, wiggle the wires at each connector to see if there is a defective plug/cable. "


    Just disconnected the subwoofer connections from my audio card. No crackling or anything. The subwoofer is powered on, and the speakers were crackling quite a bit until I disconnected the plugs from the audiocard, now I hear nothing whatsoever.

    Also, the front two speakers aren't using any extension cable, and they pop as well when everything's connected and the plugs are in the audiocard.
  • harekrsna

    25 Posts

    644

    0

    Posted March 12th, 2006 13:00

    " I would look at all the connections in the speaker system and make sure all plugs are fully inserted as a loose or plug not fully inserted can cause this. A bad cable can also cause the cracking. I'd especially look at the extension cable you installed, and make sure it's the correct type and that it is not pinched anywhere or broken and causing problems. I suspect that if you disconnect the speakers from the PC and then power on the speakers you will still get the noise which further isolates it to the speaker system. Even if everything is fully plugged in, etc, unplug each connector and then replug it just in case one isn't making good contact. Also, wiggle the wires at each connector to see if there is a defective plug/cable. " Just disconnected the subwoofer connections from my audio card. No crackling or anything. The subwoofer is powered on, and the speakers were crackling quite a bit until I disconnected the plugs from the audiocard, now I hear nothing whatsoever.
  • fireberd

    11 Legend

    •

    33399 Posts

    •

    112848 Points

    644

    0

    Posted March 12th, 2006 14:00

    Since the headphones are also doing it, that would put the suspect on the sound card and drivers. However, physically disconnect the speakers from the PC and then try the headphones again to see if you still get the crackling.  If the speakers are generting the noise it could feedback through the sound card and you could hear it on the headphones.

    The Dell supplied OEM sound cards must use Dell provided drivers for proper operation.  I'm surprised you got any retail drivers to even detect the card. 

    If this is a Retail SB Audigy 2 then you must use the retail drivers.  The SB Live! drivers are the wrong drivers and again should not have even installed and should have detected no SoundBlaster product. 

    The first thing, I would suggest, is to download the correct drivers.  If it's Dell supplied then it will be listed in the downloads for your specific model.  When you go to the Dell downloads, enter your Service Tag ID so you get the drivers for your system.  There are several Auidgy models, an "Audigy", "Audigy 2" and the latest an "Audigy 2ZS".  Since it's an 8250 and if it was Dell supplied I would suspect it's either an Audigy or Audigy 2 as the ZS models came out later. But, are you sure it's an Audigy? - many Dell's came with the SoundBlaster Live! model sound cards.

    If it's a Retail, then download the correct model drivers from SoundBlaster.

    Next, uninstall any currently installed drivers then restart Windows.  When Windows restarts it may ask you if you want Windows to search for drivers - do not allow Windows to search.  Then when Windows is started, you cn instll the appropriate SoundBlaster drivers that you've downloaded.  After the install, restart Windows and then see if it works correctly.

    Inspiron 16 5630 Laptop and WD22TB4 Docking Station
    Self-built desktop for recording studio application
  • harekrsna

    25 Posts

    644

    0

    Posted March 12th, 2006 14:00

    Sorry, spoke too soon, doesn't seem like the headphones are crackling after all. Must have been the file I was listening to. But the speakers definitely crackle, so there must be something wrong with them. Can't be the audiocard or the driver I guess.
  • harekrsna

    25 Posts

    644

    0

    Posted March 12th, 2006 15:00

    Sorry, my mistake again. I just remembered, I did swap out SB Live 5.1 with Audigy 2 soundcard a couple of years ago.

    I just couldn't remember if I did until now.

    Anyway, the audigy 2 drivers installed fine when I tried them just now.

    I don't think it's the drivers anyway, it seems your prior assumption was correct, the rear speakers seem to be the problem. When I go into audio console and click 5.1 speakers, I'll hear crackling and popping from all my speakers, but if I do only 2.1 speakers, I won't get that problem it seems. I just don't know what to do about the rear speakers though, I've checked the connections and they're all secure. It's possible my handyman who set up these speakers for me by running the wires for the rear speakers along the wall may have cut through the wires a bit when he stapled them to the wall. They're altec lansing 5.1 speakers, and they're directly attached to the speakers themselves, so I can't just swap out the wires from what I can tell.

    any suggestions for this?

    By the way, thanks a lot for your time and patience in answering my questions, I really do appreciate it. I'm sorry about all the contradictory statements I've been making, but I was just confused as to what was actually in my comp. I haven't opened it up in a while, and it has been a long time since I've added anything new to it.
  • harekrsna

    25 Posts

    644

    0

    Posted March 12th, 2006 15:00

    "Since the headphones are also doing it, that would put the suspect on the sound card and drivers. However, physically disconnect the speakers from the PC and then try the headphones again to see if you still get the crackling. If the speakers are generting the noise it could feedback through the sound card and you could hear it on the headphones.

    The Dell supplied OEM sound cards must use Dell provided drivers for proper operation. I'm surprised you got any retail drivers to even detect the card.

    If this is a Retail SB Audigy 2 then you must use the retail drivers. The SB Live! drivers are the wrong drivers and again should not have even installed and should have detected no SoundBlaster product.

    The first thing, I would suggest, is to download the correct drivers. If it's Dell supplied then it will be listed in the downloads for your specific model. When you go to the Dell downloads, enter your Service Tag ID so you get the drivers for your system. There are several Auidgy models, an "Audigy", "Audigy 2" and the latest an "Audigy 2ZS". Since it's an 8250 and if it was Dell supplied I would suspect it's either an Audigy or Audigy 2 as the ZS models came out later. But, are you sure it's an Audigy? - many Dell's came with the SoundBlaster Live! model sound cards.

    If it's a Retail, then download the correct model drivers from SoundBlaster.

    Next, uninstall any currently installed drivers then restart Windows. When Windows restarts it may ask you if you want Windows to search for drivers - do not allow Windows to search. Then when Windows is started, you cn instll the appropriate SoundBlaster drivers that you've downloaded. After the install, restart Windows and then see if it works correctly."

    Ok, well, I went to the downloads section, entered my service tag, got a list of downloads, clicked on audio, but I only came up with two options: drivers for an integrated audio chipset which I know I don't have, and SB Live 5.1 drivers. I downloaded the SB Live 5.1 drivers, then uninstalled my SB Audigy 2 driver from device manager in control panel. Restarted the comp, and then tried to run the downloaded file which was RS69382.exe. It unzipped all its files to Dell\drivers directory, and then tried to run setup but then gave me an error message saying it didn't detect any Soundblaster card in my system, which is odd.

    I'm also pretty sure I haven't upgraded my comp ever. The system as it is now, was what it was when I first got it. Even when I tried to install audigy 2 drivers from creative's web site it would give me the same message that it didn't detect any soundblaster card. The only way I got around this was to use Windows supplied soundblaster driver, then install audigy drivers over that, since it never actually checks for a soundblaster card in the system then.
  • harekrsna

    25 Posts

    644

    0

    Posted March 12th, 2006 17:00

    Well, I unplugged the rear speakers from my subwoofer, and just have my three front speakers connected, AND I have audio console set to 2.1 speakers, and I'm STILL getting crackling, just less frequent. This is very confusing. There shouldn't be a problem with the front three speakers (front left, center, front right), since their connections haven't changed or anything.
  • fireberd

    11 Legend

    •

    33399 Posts

    •

    112848 Points

    393

    0

    Posted March 13th, 2006 10:00

    So you did change out the sound card.  One more way to check the speakers, if you have a portable MP3 player or a portable CD player, plug the powered speakers into the portable device and see if you still get crackiling sound.  If you do then you've definately isolated it to the speakers. 
     
    If you don't get any crackling with the speakers plugged into something other than the PC, power off the PC, open the case and "reseat" the Audigy sound card.  Reseat - remove the card from the PCI slot connector and then reinsert the card in the connector making sure it's fully and properly seated.  Then restart the PC and see how it works.  Windows may detect "new hardware" since the card was reseated. 
    Inspiron 16 5630 Laptop and WD22TB4 Docking Station
    Self-built desktop for recording studio application