UNSOLVED

scottishfarmer

updated

20 years ago

0

9589

May 10th, 2007 21:00

DIMENSION 9200 - SURROUND SOUND

I have just purchased a new dimension 9200 running Vista with a Sound blaster X-Fi Xtreme sound card and Dell 5650 speakers and subwoofer and monitor speaker.
I can only get sound out of 2 speakers and the subwoofer. The other speakers are live but no sound comes from them.
I have looked in the control panel for settings and discovered it is set for 2.1 sound but does not give the option to set for 5.1.
Does anyone know how to change this setting on vista?
 
Regards
Scottish farmer
  • Jesse L (retired)

    10 Wizard

    •

    17898 Posts

    •

    69016 Points

    146

    0

    Posted May 11th, 2007 10:00

    scottishfarmer,

    Thank you for using the Dell Community Forum.

    Try going into the 3dMidi to choose the speaker options within the sound cards software.

     

    Jesse L (retired)

  • 146

    0

    Posted May 12th, 2007 21:00

    Hi Jesse,
    Thanks for your reply.
    Unfortunately i do not have a speaker option on the 3d midi player option on the creative sound card.
    I still think it is only a speaker setup problem, but i cannot find the option to change setting to 5.1 surround sound anywhere on my computer.
    Anymore ideas where to look?
     
    Regards
    Scottish Farmer
  • Stephan02

    25 Posts

    146

    0

    Posted May 13th, 2007 13:00

    Hi scottishfarmer,

    I have experienced the very same problem today. Apparently there the X-Fi drivers supplied with the Dimnesion 920 do not cooperate very well with Windows Vista. They do show the speaker setup correctly in the fancy "Creative Console Starter" tool, but you can not change them.

    What you see shown is in fact the speaker setup setting of Windows Vista. Consequently you can change the speaker setup in the Vista Control Panel. Microsoft made this hard to find, but I am good at searching for cleverly hidden features :-)

    Open the "Sound" component of the Control Panel. The first TAB shows speakers. Click on speakers, then click the "Configure" button in the bottom left corner. Voila :-) Choose 5.1 and all your speakers will become active and available. After you OK'ed all the changes the Creative Tool will now also show that you are using a 5.1 speaker setup.

    Hope this helped,
    Stephan

    Message Edited by Stephan02 on 05-13-2007 04:35 PM
  • 146

    0

    Posted May 13th, 2007 14:00

    Hi Stephan02
     
    You are a genius. I followed your instructions and was able to select 5.1 from the options and now all my speakers are working perfectly.
     
    Thankyou for your help.
     
    Regards
    Scottish Farmer