NVIDIA MX550 disappeared from Inspiron 16 7620 2-in-1 (Code 45) — survived RTC
reset and BIOS 1.32.0. Anyone seen this recently?
System: Inspiron 16 7620 2-in-1 CPU: 12th Gen Intel Core i7-1260P GPUs: Intel Iris Xe (working) + NVIDIA GeForce MX550 (missing) OS: Windows 11 Pro, build 26200 BIOS: 1.32.0 (currently); was on 1.30.1 when the problem started Warranty: out of warranty
What happened
My MX550 has completely disappeared from the system. The laptop otherwise runs perfectly because the Intel Iris Xe drives all my displays, so I didn't notice for a while.
In Device Manager, the MX550 still appears under Display adapters, but its status reads: "Currently, this hardware device is not connected to the computer (Code 45)." Running nvidia-smi returns "NVIDIA-SMI has failed because it couldn't communicate with the NVIDIA driver." The NVIDIA driver installer (596.08) refuses to proceed, reporting "No NVIDIA GPU is detected on your system."
When it started
I went back through the Windows System event log. The last time the OS ever saw the MX550 (PCI\VEN_10DE&DEV_1F9F) was May 13, 2026, when a Windows-delivered NVIDIA driver update installed. From May 14 onward — right after the KB5089549 cumulative update installed across a few reboots — there is zero trace of the NVIDIA device in the log: no driver load, no PnP removal event, no error. It simply stopped enumerating. This was all on BIOS 1.30.1 at the time.
What I've tried, without success
Checked Device Manager — MX550 present but Code 45 ("not connected"). No yellow warning icon; the entry is essentially a ghost.
Disable / re-enable the device — no change.
Full shutdown and normal restart (Fast Startup involved) — no change.
RTC reset / flea-power drain — AC connected, held power button ~30–35 seconds until the power LED blinked three times, released. The system restarted several times and showed the recovery/boot menu (Continue / BIOS Setup / Diagnostics), and the clock/BIOS settings reset afterward, so I confirmed the reset actually executed. GPU still missing.
BIOS update to the latest, 1.32.0 (from 1.30.1), run on AC power, completed successfully (verified in System Information). GPU still missing.
Attempted NVIDIA driver reinstall — installer aborts because it detects no compatible hardware.
nvidia-smi — still reports it can't communicate with the driver.
Questions for the community
Has anyone with a 7620 (or the related 7420) seen the MX550 vanish like this recently — specifically after a Windows-delivered NVIDIA driver update or a Windows cumulative update?
Did anything recover it short of a mainboard replacement (deeper firmware reflash, EC reset, service-bench procedure)?
For those who went the service route: was it diagnosed as a mainboard fault, and roughly what did the repair involve?
Before I contact Dell support directly, I'd like to know whether this is a known recent pattern. Any pointers appreciated. Thanks.
Unplug the system and remove the base cover. Disconnect the battery from the mainboard and hold the power button for 30 sec.
Reassemble the system and power up. It will take a couple of cycles to complete POST and boot. Once in Windows, check the device manager - if the discrete GPU is still missing (i.e., there's only one video adapter entry), the GPU has failed. The only repair at that point is a replacement system board.
Try downloading the latest Dell provided Iris Xe and Nvidia MX550 drivers. Unplug any external displays. Uninstall the existing Nvidia MX550 driver. Uninstall the existing Iris Xe driver. Reboot and the basic Microsoft driver will be utilized. The screen resolution will probably not be right. Don't worry about it for now. Install the the Iris Xe driver, reboot if necessary. Make sure you set the correct screen resolution/refresh rate if necessary. Install the Nvidia MX550 driver. If you don't have a hardware problem you should be good to go now. The key here is the order in which the video drivers are installed.
ejn63
12 Elder
•
31847 Posts
•
156271 Points
2
0
Posted July 9th, 2026 13:15
Unplug the system and remove the base cover. Disconnect the battery from the mainboard and hold the power button for 30 sec.
Reassemble the system and power up. It will take a couple of cycles to complete POST and boot. Once in Windows, check the device manager - if the discrete GPU is still missing (i.e., there's only one video adapter entry), the GPU has failed. The only repair at that point is a replacement system board.