PS4000 grpadmin not working afer upgrade FW from 9.1.1 to 9.1.9
Hello,
After upgraded a PS4000 from the release 9.1.1 to 9.1.9 the usual password of grpadmin don't work any more...
Moreover the IP address seems to be lost because the SAN doesn't respond anymore.
During the upgrade thru the "Storage Update Manager" everything work as expected. I could login/logout via ssh or serial without issues.
After the first part, the manager ask for reboot the ARRAY. I did it and I see on the seral screen 2 reboot without error.
But now if I try to login in console mode the the password seems to be not recognize (or disabled thru this terminal) and I can't ping or connect via ssh (IP).
You can't disable logins at the serial port, so that's not the issue. The array is down, that's why it's not responding to IP or pings. Something interrupted the boot process. have you tried connecting to the other controller?
During an upgrade restart the passive controller is rebooted first. Then once that finishes the active controller fails over to the upgraded controller. Then finally the last controller is restarted to finish it's update.
If that process doesn't complete properly you can end up booting off the wrong version of firmware. So try connecting to the other controller. If you get in do a:
CLI>show members
CLI>member select MEMBERNAME show controllers
'membername' is the name of the physical array.
CLI>member select EQL-Member1 show controllers
Please copy and paste the output (don't use screeenshots)
dwilliam62
6 Operator
•
1516 Posts
•
6374 Points
599
1
Posted September 25th, 2020 07:00
Hello,
You can't disable logins at the serial port, so that's not the issue. The array is down, that's why it's not responding to IP or pings. Something interrupted the boot process. have you tried connecting to the other controller?
During an upgrade restart the passive controller is rebooted first. Then once that finishes the active controller fails over to the upgraded controller. Then finally the last controller is restarted to finish it's update.
If that process doesn't complete properly you can end up booting off the wrong version of firmware. So try connecting to the other controller. If you get in do a:
CLI>show members
CLI>member select MEMBERNAME show controllers
'membername' is the name of the physical array.
CLI>member select EQL-Member1 show controllers
Please copy and paste the output (don't use screeenshots)
Regards,
Don