How to set failover mode in "agent.config" file of Navisphere agent?
I use a clariion with flare code 26 for a HP-UX 11iv 3 server running native multipathing.
Therefore I have to set the failover mode to 4.
When the Navisphere agent is started on this server at boot time, the failover mode is automatically set to 1, which is wrong and causes problems for this configuration.
Is there is a possibility to add a line to the Navisphere agent config file named "agent.config" to set failover mode to 4?
I set the failover mode through the failover wizard but the settings will be overwritten when starting the Navisphere agent on the HP server. This means I cannout use the Navisphere agent on 11i v3 (aka 11.31) servers. Is there a way to configure the Navisphere agent correctly for 11i v3, i.e. setting the failover mode in config file?
Hi, Look for line "OptionsSupported AutoTresspass " in the /etc/Navisphere/agent.config file. Uncomment this line. Add another line on top of agent.confg file with only one line nomegapoll . Save the file and stop and start Navi Agent.
Initiator Type - HP no auto trespass Array Systemtype - N/A Arraycommpath - 1(Enabled) Failovermode - 4 UnitSerialNumber - LUN or Array
Note: If using the Navisphere agent.config file, ensure that the appropriate "OptionsSupported" setting is in the file, otherwise the initiator setting on the array will be changed when the Navisphere agent starts up. To maintain the Navisphere Manager initiator setting, uncomment the "OptionsSupported" line in the agent.config file, and change it to state "OptionsSupported ArrayType".
bishtsudhir
81 Posts
145
0
Posted June 20th, 2008 20:00
Thanks