UNSOLVED

kpannell

updated

20 years ago

K

kpannell

12 Posts

0

1575

December 4th, 2006 12:00

Clariion Devices showing up as FAILED on INQ and the device doesn't exist

On one of my HPUX servers running HPUX 11.11 I have several Clariion devices showing up as FAILED on inq output under the capacity column. When I run an ioscan to look for the devices they do not exist. I have 2 questions - what causes this and how do I clean this up?
  • dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    506

    0

    Posted December 4th, 2006 12:00

    do you have powerpath on this box or you use pvlinks ? If you have powerpath, can you run powermt display ..does it display anything "dead" ?
  • kpannell

    12 Posts

    506

    0

    Posted December 5th, 2006 07:00

    I am running power path on this machine, but there is nothing showing up as dead.
  • dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    506

    0

    Posted December 5th, 2006 08:00

    can you manually trespass those luns to another SP ..run ioscan and then insf. I am curious the see if it's going to create a device file then. Also did you use navi agent to register the box in Navisphere or did you manually register ..under connectivity status what is this host failover mode is set to ?
  • kpannell

    12 Posts

    506

    0

    Posted December 5th, 2006 08:00

    The luns don't appear to be in the storage group so I have nothing to trespass.
  • kpannell

    12 Posts

    506

    0

    Posted December 5th, 2006 08:00

    I don't expect to see them. I believe that these are devices that may have been there at one time and were removed from the host. As I mentioned in the first thread the only place I am seeing any reference to these devices is on inq.
  • dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    506

    0

    Posted December 5th, 2006 08:00

    if they are not in the storage group ..how are you expecting to see them on the host ? Is this direct attach ? Do you have access logix running ?
  • kpannell

    12 Posts

    506

    0

    Posted December 5th, 2006 08:00

    It is possible that I manually registered the agent because when we upgraded the version of navisphere I upgraded the agent prior. By doing it this way I was required to manually register the agent.

    The failover mode is set to 1.
  • dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    506

    0

    Posted December 5th, 2006 10:00

    Do you have solutions enabler installed on this box ? does syminq show these devices ?
  • kpannell

    12 Posts

    568

    0

    Posted December 5th, 2006 11:00

    For all of the Clariion devices except the ones in question the number under the num column is a four digit number. For the ones in question I'm seeing this number 2013158376. Now that I'm looking at it, it is not multiple devices, but multiple paths to a device.
  • dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    568

    0

    Posted December 5th, 2006 11:00

    what do you see when you run:
    syminq -clariion -wwn